Yan Li

Yan Li

Auto-generated profile, based on publicly available information

Yan Li

Electric Power Research Institute, China Southern Power Grid, Guangzhou, China

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 February 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
CZChangyue Zou
Changyue Zou
HRHong Rao
Hong Rao
SXShukai Xu
Shukai Xu
YLYan Li
Yan Li
WLWeiwei Li
Weiwei Li
BLBo Lei
Bo Lei
A 1270 Hz resonance occurred between ±350 kV/ 1000 MW Luxi back-to-back voltage source converter based high-voltage dc transmission (VSC-HVDC) converter and the 525 kV ac grid after disconnection of several ac transmission lines. To understand the resonance and find a solution, the impedance-based stability analysis model considering different equipment is first established. Then, the resonance is analyzed and repeated in the simulation based on the established model. The system stability can be judged by the ratio of grid impedance to the equivalent impedance of all parallel-connected equipment with the converter. To evaluate the occurrence and risk of resonance, the frequency range where the impedance has a negative-real-part has been searched and studied. In order to narrow the negative-real-part region to avoid potential resonance, solutions such as control strategy improvement and passive or active impedance adapter may be applicable and are discussed. For a complex system containing various equipment, the equipment can be divided into several subsectors to avoid modeling all possible combinations of equipment, which can be exhausting. And analysis has shown sufficient but not necessary condition to stabilize the system is to avoid the negative-real-part region in each sector.

4 September 2018 in IEEE Transactions on Power Delivery
Verified
Journal Article
Closed access
NTNing Tong
Ning Tong
XLXiangning Lin
Xiangning Lin
YLYan Li
Yan Li
ZHZhihao Hu
Zhihao Hu
NJNeng Jin
Neng Jin
ZLZhengtian Li
Zhengtian Li
To ensure the continuous operation of the VSC-MTDC, there has been much concern regarding how to isolate the single-pole earth fault by means of protective relaying. However, when the boundary components are not on the DC transmission lines, conventional main protections for the HVDC systems perform less satisfactorily. To solve this problem, a local measure-ment-based ultra-high-speed main protection is proposed in this manuscript. The proposed method is achieved by the co-operation of the single-end directional start-up criterion and the surge arrival time difference between the 0-mode and 1-mode traveling waves. According to the simulation results, the proposed method has satisfactory performance against internal faults and is quite reliable in external fault and operating condi-tion changes. Meanwhile, the reach is also wide enough to cover most of the protected line. Comparison studies are also con-ducted among the proposed protection and three types of exist-ing protection schemes, highlighting the advantages of the pro-posed protection in terms of selectivity, operating speed and resistive tolerance.

4 September 2020 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
JWJianpeng Wang
Jianpeng Wang
WCWenjie Chen
Wenjie Chen
LWLaili Wang
Laili Wang
BWBinyu Wang
Binyu Wang
CZCheng Zhao
Cheng Zhao
YLYan Li
Yan Li
Junction temperature is a key parameter for the safe operation of power semiconductor devices in power electronic systems. However, it’s difficult to forecast the accurate thermal stress of device in field use. Consequently, engineers tend to use higher rated devices to maintain excessive margin, resulting in higher cost. In this paper, a transient 3D thermal modelling method for IGBT modules is proposed to obtain accurate temperature distribution considering uneven power losses and cooling conditions. The analytical model of uneven switching energy losses among the parallel IGBT chips in modules are built up according to the analysis on device simulation results. The effect of uneven cooling conditions on temperature distribution in IGBT modules is considered by thermal-fluid co-simulation. Further, a hybrid simulation strategy is proposed to obtain the transient thermal behavior in three dimensions. Through appropriate interface design, the power loss model is connected with finite element model to achieve field-circuit co-simulation with multiple time steps, which takes full consideration of the multi-physical coupling effects among power loss, temperature and flow fields. Finally, the thermal stresses of IGBT modules under different operating conditions are forecasted by the proposed method.

1 October 2019
Verified
Conference Paper
Closed access
Weiwei LiWeiwei Li
Weiwei Li
YLYan Li
Yan Li
YSYu Songtao
Yu Songtao
TWTianliu Wei
Tianliu Wei
JCJianfu Chen
Jianfu Chen
SXShukai Xu
Shukai Xu
Considered as an important option to enhance power distribution capacity, improve operation flexibility and increase power quality in distribution grids, the medium-voltage DC (MVDC) technology has gained increasing interests in recent years. In this paper, the state of the art of researches and applications of MVDC distribution system is presented. Main topics and progresses are explored including planning and evaluation, main circuits, key equipment, control and protection. The most recent pilot projects around the world are introduced among which the Tangjia Bay pilot project with the largest capacity is illustrated in detail, together with the practical issues during the design, experiment, and commissioning.

5 August 2019 in Journal of Electrical Engineering & Technology
Verified
Journal Article
Closed access
PDF file
DXDa Xie
Da Xie
LZLuqing Zhang
Luqing Zhang
CGChenghong Gu
Chenghong Gu
YLYan Li
Yan Li

25 November 2024 in Electronics
Verified
Journal Article
Open access
PDF file
YLYan Li
Yan Li
WYWentao Yang
Wentao Yang
XWXiaofang Wu
Xiaofang Wu
RCRunbin Cao
Runbin Cao
WHWeihuang Huang
Weihuang Huang
JHJunjie Hou
Junjie Hou
It has become a typical scenario in power systems that renewable energy power supply is connected to an AC system through flexible DC transmission. However, since both sides of the AC line are power electronic converters, the negative sequence suppression strategy will be put into the converters at both ends during the asymmetric fault, which causes fundamental changes in the fault characteristics of the system, which is reflected in the two-terminal weak-feed characteristics, leading to the decline of traditional protection performance and affecting the safe operation of the system. Therefore, this paper presents a directional element of a double-ended weakly fed AC system with a negative sequence control strategy. Firstly, the characteristics of the negative sequence impedance under the negative sequence suppression strategy are analyzed when the AC line has asymmetric faults. Secondly, the difference in negative sequence impedance amplitude is analyzed. Finally, the direction element is constructed by the method of de-wave trend analysis The proposed scheme can realize the rapid identification of fault directions at both ends. The simulation results show that the proposed scheme is suitable for a two-terminal weak-feed AC system and can operate reliably under 300 Ω transition resistance and 20 dB noise interference.