27 September 2023 in Journal of Lightwave Technology
Silicon Photomultipliers (SiPMs) can provide optical wireless communication (OWC) receivers with better sensitivities than PIN photodiodes, thanks to their photon counting capabilities. The commercial availability of SiPM with fast output pulse width allows high-speed data transmission at low irradiance levels. This article investigates the use of a commercially available SiPM with an active area of 1 mm 2 and fast output pulse width of 0.6 ns in a Near-infrared (NIR) OWC link and compares the performance of a 3 mm x 3 mm SiPM with a fast output pulse width of 1.4 ns. Although both SiPMs have maximum detection efficiency at 450 nm, a wavelength of 850 nm is used owing to the availability of high-speed VCSELs, higher eye safety limit and ability to filter ambient light when using this wavelength. The OWC link is designed and tested at a 35 cm transmission distance using On-Off-Keying (OOK) and Decision Feedback Equalization (DFE), and a maximum data rate of 8.2 Gbps at a BER of 3.8 × 10 −3 was obtained with 15.34 W/m 2 irradiance at the SiPM. These results are achieved in the dark and under 500 lux of White Light Emitting Diode (WLED) ambient light. A long pass colour glass filter is used to reject light up to 700 nm wavelength, thus rejecting most of the interference from WLEDs, resulting in data rates similar to dark environments. This is the highest data rate achieved using SiPMs in an NIR link.
20 May 2020 in IEEE Journal of Radio Frequency Identification
A novel ultra-high-frequency (UHF) RFID reader antenna is proposed, designed and measured. The proposed antenna is capable of 2-dimensional (2D) beam-scanning from 0∘ to 360∘ in the azimuth plane, and 0∘ to 40∘ in the zenith plane. The minima of the antenna’s axial ratio (AR) follows its gain maxima during beam-scanning, resulting in an equivalent 3 dB AR beamwidth of over 136∘ for every phi cut. Moreover, the antenna’s AR can be easily modified without affecting other parameters. It is shown experimentally that the antenna’s 2D beam-scanning ability and the improved AR performance lead to better tag-reading results, improving the percentage of missing tags by up to 21.6% compared to a standard antenna which has a degraded AR and only supports 1D beam-scanning. In addition, the antenna needs no matching network and has a -10 dB return loss bandwidth from 860 MHz to 880 MHz.
2 October 2025 in Journal of Lightwave Technology
A 5 × 5 VCSEL array-based optical wireless communication multi-beam transmitter is designed and simulated. Each element of the array addresses a separate spatial attocell. A microlens-array based homogenizer achieves uniform coverage at the receiver plane from each multi-mode VCSEL output. 1 m2 total coverage is achieved with each attocell covering an area of 400 cm2 at a range of 3 m. For a proof-of-concept demonstration a 1 × 3 channel VCSEL array-based transmitter prototype is experimentally tested. The performance is verified by demonstrating three channels achieving ∼0.12 mW/m2 uniform power with negligible optical interference to adjacent attocells (<−14 dB). With a simple receiver design using low cost, off-the-shelf components, each channel of the transmitter achieves ∼10 Gb/s throughput using OFDM within 7 cm lateral range and >4 Gb/s within 12 cm lateral range at 3 m. The transmitter meets eye-safety restrictions and could be scaled to 250 Gb/s aggregate data rate by employing all 25 VCSELs with independent OFDM modulation.