A relationship between irradiance and the current needed to maintain the bias voltage applied to a silicon photomultiplier (SiPM) is shown to agree with experimental data. In addition to showing the saturation of the SiPMs response this relationship can be used to determine the power consumed by an SiPM. In addition, results are presented which show that, because of its higher maximum photon count rate, a 30020 SiPM can achieve a bit error rate (BER) of 10 -3 at a data rate of 3.45 Gbits/s.
In this paper we demonstrate a novel optical receiver for visible light communications that combines a fluorescent antenna and a silicon photomultiplier (SiPM). The fluorescent antenna is configured in a slab geometry to collect and absorb an incoming optical data signal, and to waveguide the resulting fluorescence to an edge where it is detected by the SiPM. The antenna incorporates the fluorophore, pentafluorene, selected for its very high bandwidth of 245 MHz, high photoluminescence quantum yield of 90%, and emission spectrum that matches the wavelengths most efficiently detected by the SiPM. The performance of a receiver, comprising the fluorescent antenna and a J-series 30020 SiPM manufactured by ON Semiconductor, was assessed in a 30 cm data link with a 405 nm GaN laser diode transmitter, both in the dark and under 500 lux of ambient white light. The fluorescent antenna successfully rejects ambient light by a factor of 20, limited by extrinsic scattering in the thin film. Using on-off-keying with decision feedback equalization, a maximum data rate of 1.4 Gbps was demonstrated in 500 lux of ambient light. Using the pentafluorene antenna plus a BG3 filter, provides a 200 fold suppression of ambient light, and can increase the data rate of the receiver at low signal powers by up to a factor of 2. When operating in ambient light the composite receiver requires only 2.5 times more signal power than when it operates in the dark, with this power penalty reducing to a factor of 1.2 at 1 Gbps.
19 March 2021 in IEEE Photonics Technology Letters
Results of an investigation into the performance of a wide field of view silicon photomultiplier (SiPM) receiver under ambient light are reported. During these investigations a new form of inter-symbol interference (ISI) was discovered, which can be attributed to saturation of the SiPM. This new form of ISI means that using decision feedback equalization (DFE) improves the receiver's performance at low data rates.
Fluorophore doped plastic optical fibers can be used to create optical concentrators in receivers for visible light communications, that also act as wide field of view filters. Increasing the length of these fibers allows them to collect more of the signal from the transmitter, however, it can also reduce the bandwidth of the fiber. Results are presented from 3 different lengths of fiber which show that the best length of a fluorescent fiber depends upon the data rate. However, a simple calculation results in a length that is a good choice for a range of OOK data rates.
4 November 2021 in Journal of Lightwave Technology
The range of transmitters, detectors and other components that can be used in optical wireless links means that they can have a wide variety of frequency responses. Both pre- and post- equalization have been used in optical wireless systems to increase data rates. Pre-equalization has the advantage that noise impairments due to equalization can be minimised. However, the variety of pre-equalizer transfer functions, which can be easily created using analog circuits, is limited by the frequency responses of these circuits. Consequently, it may not be possible to equalize some optical wireless links with analog circuit-based pre-equalizers. In this paper a flexible digital pre-equalization scheme that can equalize complex frequency responses is described. The flexibility and the applicability of the scheme is also demonstrated using two example systems, including one that incorporates a fluorescent optical fiber to create a wide-field-of-view receiver for handheld devices. In particular, the bandwidths of the two example systems have been increased to over 500 MHz and to 350 MHz, resulting in at least a three-fold increase in data rate without any post-equalization. The authors believe that this is the first time such significant improvements in on-off-keying data rates have been demonstrated in systems with a relatively complex frequency response and a limited dynamic range.