Vitaly O. Nekhoroshev

Vitaly O. Nekhoroshev

Auto-generated profile, based on publicly available information

Vitaly O. Nekhoroshev

Tomsk Polytechnic University

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 December 2023 in Vacuum
Verified
Journal Article
Closed access
DZD.A. Zuza
D.A. Zuza
VNV.O. Nekhoroshev
V.O. Nekhoroshev
ABA.V. Batrakov
A.V. Batrakov
AMA.B. Markov
A.B. Markov
ACAleksandr V. Chernyavskii
Aleksandr V. Chernyavskii
Irina KurzinaIrina Kurzina
Irina Kurzina

1 August 2019 in Journal of Physics Communications
Verified
Journal Article
Open access
YKY D Korolev
Y D Korolev
VNV O Nekhoroshev
V O Nekhoroshev
OFO B Frants
O B Frants
NLN V Landl
N V Landl
ASA I Suslov
A I Suslov
VGV G Geyman
V G Geyman
The paper describes the investigations of a low-current discharge in airflow with the electrode configuration of coaxial plasmatron. An inner diameter of the plasmatron nozzle is of 0.5 cm and the mass airflow rate is from 0.1 to 0.3 g s−1. Typical averaged discharge current is varied from 0.06 to 0.2 A. In these conditions, due to airflow the so-called plasma jet forms in the plasmatron nozzle and at its exit. The total current in plasmatron mainly flows via the constricted plasma column of the glow discharge and only a small fraction of current is carried by the jet. The principal idea of the experiments is to reveal the mechanism of the jet formation and to elucidate how the nonsteady discharge regimes influence on the jet properties. We have proposed the method for the jet diagnostics, which is based on measuring the currents to the additional diagnostic electrodes located outside the nozzle. The obtained data show that the jet current forms due to electrons that are emitted from the boundary of plasma column. The temporal behavior of the jet current is determined by the position of the column inside the plasmatron nozzle, which changes with time. Hence, the term ‘plasma jet’ has to be used with care, since the charged particles in the jet area are the electrons. The estimated electron density in the jet is of about 109 cm–3.

1 November 2022 in Plasma Sources Science and Technology
Verified
Journal Article
Closed access
YKY D Korolev
Y D Korolev
NLN V Landl
N V Landl
ABA V Bolotov
A V Bolotov
VKV S Kasyanov
V S Kasyanov
VNV O Nekhoroshev
V O Nekhoroshev
ISI A Shemyakin
I A Shemyakin
Data are presented on an investigation of pulsed discharges in a solution of 30 g of NaCl per liter of distilled water. The interelectrode gap consists of the active pin electrode and the return plane electrode. The voltage pulse of positive polarity forms by means of an electric circuit where a capacitor bank of 40 μ F with an initial voltage V 0 of up to 1500 V is discharged via the gap. In a range of initial voltages V 0 = (550 – 1100) V vapor cavities in a form of the microbubbles are generated near the active electrode and at the electrode surface. The microbubbles are able to merge with each other thus forming macrobubbles and vapor layers, which shield the active electrode from current passage. The process of vapor cavity generation and the effect of shielding are discussed in detail. The discharge at the vapor layer appears at the critical voltage V 0 = 1100 V. The principal prerequisite for discharge arising is that the electrode has to be completely shielded by the vapor layer and the voltage at the layer at the instant of discharge initiation has to be at least at a level of 500 V. However, when the voltage at the gap exceeds the critical value, the condition of complete shielding is not obligatory.

1 February 2024 in Russian Journal of Nondestructive Testing
Verified
Journal Article
Closed access
PDF file
DDDaria Derusova
Daria Derusova
VVVladimir Vavilov
Vladimir Vavilov
VNV. O. Nekhoroshev
V. O. Nekhoroshev
VSV.Y. Shpil’noy
V.Y. Shpil’noy
DZDaniil Zuza
Daniil Zuza
EKEkaterina Kolobova
Ekaterina Kolobova
In this study, a gas discharge electroacoustic transducer (GDEAT) based on a pulsed electric discharge in the air under atmospheric pressure has been investigated. The acoustic characteristic of GDEATs have been determined in the frequency range from 40 Hz to 4 MHz by evaluating acoustic pressure and recording amplitude–frequency characteristics of membranes. The electrothermoacoustic processes have been studied in open type gas discharge systems where the electrode space is in a direct contact with the environment. Some features of using the above-mentioned GDEATs in material nondestructive testing (NDT) have been demonstrated. It has been shown that, on the one hand, the wear of both electrodes and insulation limits the work life of transducer’s electrode system; however, on the other hand, this may lead to deposition of microparticles on the test object surface. The wear of the electrode system was evaluated quantitatively. The results of the chemical analysis of the deposited microparticles are presented. The possibility of using GDEATs for noncontact stimulation of local resonant vibrations in subsurface defects and visualizing vibrations by means of laser Doppler vibrometry is shown in the case of NDT of a glass fiber composite.

27 January 2024 in Russian Physics Journal
Verified
Journal Article
Closed access
PDF file
NLN. V. Landl
N. V. Landl
VNV. O. Nekhoroshev
V. O. Nekhoroshev
YKY. D. Korolev
Y. D. Korolev
OFO. B. Frants
O. B. Frants
VKV. S. Kasyanov
V. S. Kasyanov

1 December 2024 in Russian Journal of Nondestructive Testing
Verified
Journal Article
Closed access
PDF file
DDDaria Derusova
Daria Derusova
VNV. O. Nekhoroshev
V. O. Nekhoroshev
VSV.Y. Shpil’noy
V.Y. Shpil’noy
ARA. V. Raut
A. V. Raut
The results of the study of a gas-discharge electroacoustic transducer operating based on a pulse discharge in air at atmospheric pressure are presented. The influence of the electrode system configuration on the acoustic characteristics of the transducer is considered. It is shown that changing the discharge chamber volume and the interelectrode gap significantly affects the radiation intensity. Features that arise when using electroacoustic transducers of open and closed types for NDT tasks are identified. It is demonstrated that the open-type gas-discharge electroacoustic transducer is a sufficiently powerful broadband excitation signal source and has prospects for application in non-destructive testing. The closed-type gas-discharge electroacoustic transducer has advantages when studying materials with special requirements for surface cleanliness or the magnitude of the applied external electric field.