In response to climate and resource challenges, the transition to a renewable and decentralized energy system is imperative. Ultrathin Cu(In,Ga)Se2 (CIGS)‐based solar cells are compatible with such transition due to their low material usage and improved production throughput. Despite the benchmark efficiency of CIGS technology, ultrathin configurations face efficiency drops arising from increased rear interface recombination and incomplete light absorption. Dielectric passivation schemes address rear interface recombination, but achieving simultaneous electrical and optical gains is crucial for thinning down the absorber. Plasmonic nanoparticles emerge as a solution, enhancing light interaction through resonant scattering. In the proposed architecture, the nanoparticles are encapsulated within a dielectric rear passivation layer, combining effective passivation and light trapping. A controlled deposition and encapsulation of individualized nanoparticles is achieved by an optimized process flow using microfluidic devices and nanoimprint lithography. With the developed plasmonic and passivated architecture, a 3.7 mA cm−2 short‐circuit current density and a 23 mV open‐circuit voltage improvements are obtained, leading to an almost 2% increase in light‐to‐power conversion efficiency compared to a reference device. This work showcases the developed architecture potential to tackle the electrical and optical downfalls arising from the absorber thickness reduction, contributing to the dissemination of ultrathin technology.
Rear interface passivation on submicrometer Cu(In,Ga)Se2 (CIGS) solar cells through nanopatterned dielectric layers has enabled performance gains. The combined optimization of the rear contact interface and the absorber properties enables high-efficiency ultrathin CIGS solar cells. However, the absorber quality of a standard thin 2000 nm CIGS has not been suitably maintained in absorbers with thickness values around 500 nm. Establishing an optimized Na doping, absorber crystallinity, and bandgap profile on such submicrometer CIGS solar cells has been challenging. Moreover, the Na doping may also be influenced by the rear contact architectures implemented in passivated solar cells, e.g., affecting the diffusion of Na from the soda-lime glass. Nonetheless, a proper Na supply into CIGS is critical for an optimized absorber quality. Therefore, this study evaluates the impact of the amount of Na supply controlled through a NaF precursor layer on a rear passivated ultrathin CIGS solar cell. The NaF layer thickness leading to the best performance solar cells in this study, attributed to high absorber crystallinity and low ordered vacancy compound content, is lower than that used in standard thin 2000 nm cells. It suggests that the transition to ultrathin solar cells is not straightforward, and the cell architecture influences the conditions to reach the optimum absorber properties.