Olivier Donzel-Gargand

Olivier Donzel-Gargand

Auto-generated profile, based on publicly available information

Olivier Donzel-Gargand

Uppsala University

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 February 2024 in Nature Energy
Verified
Journal Article
Open access
PDF file
JKJan Keller
Jan Keller
KKKlara Kiselman
Klara Kiselman
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
NMNatalia M. Martin
Natalia M. Martin
MBMelike Babucci
Melike Babucci
MEMarika Edoff
Marika Edoff
Chalcopyrite-based solar cells have reached an efficiency of 23.35%, yet further improvements have been challenging. Here we present a 23.64% certified efficiency for a (Ag,Cu)(In,Ga)Se2solar cell, achieved through the implementation of a series of strategies. We introduce a relatively high amount of silver ([Ag]/([Ag] + [Cu]) = 0.19) into the absorber and implement a ‘hockey stick’-like gallium profile with a high concentration of Ga close to the molybdenum back contact and a lower, constant concentration in the region closer to the CdS buffer layer. This kind of elemental profile minimizes lateral and in-depth bandgap fluctuations, reducing losses in open-circuit voltage. In addition, the resulting bandgap energy is close to the local optimum of 1.15 eV. We apply a RbF post-deposition treatment that leads to the formation of a Rb–In–Se phase, probably RbInSe2, passivating the absorber surface. Finally, we discuss future research directions to reach 25% efficiency.

22 April 2022 in ACS Applied Energy Materials
Verified
Journal Article
Open access
CCCorrado Comparotto
Corrado Comparotto
PSPetter Ström
Petter Ström
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
TKTomas Kubart
Tomas Kubart
JSJonathan J. S. Scragg
Jonathan J. S. Scragg

13 February 2014 in BioMed Research International
Verified
Journal Article
Open access
PDF file
Fatemeh AjalloUeianFatemeh AjalloUeian
Fatemeh AjalloUeian
HTHossein Tavanai
Hossein Tavanai
JHJons Hilborn
Jons Hilborn
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
Klaus LeiferKlaus Leifer
Klaus Leifer
AAAyyoob Arpanaei
Ayyoob Arpanaei
Novel nanofibers from blends of polylactic-co-glycolic acid (PLGA) and chitosan have been produced through an emulsion electrospinning process. The spinning solution employed polyvinyl alcohol (PVA) as the emulsifier. PVA was extracted from the electrospun nanofibers, resulting in a final scaffold consisting of a blend of PLGA and chitosan. The fraction of chitosan in the final electrospun mat was adjusted from 0 to 33%. Analyses by scanning and transmission electron microscopy show uniform nanofibers with homogenous distribution of PLGA and chitosan in their cross section. Infrared spectroscopy verifies that electrospun mats contain both PLGA and chitosan. Moreover, contact angle measurements show that the electrospun PLGA/chitosan mats are more hydrophilic than electrospun mats of pure PLGA. Tensile strengths of 4.94 MPa and 4.21 MPa for PLGA/chitosan in dry and wet conditions, respectively, illustrate that the polyblend mats of PLGA/chitosan are strong enough for many biomedical applications. Cell culture studies suggest that PLGA/chitosan nanofibers promote fibroblast attachment and proliferation compared to PLGA membranes. It can be assumed that the nanofibrous composite scaffold of PLGA/chitosan could be potentially used for skin tissue reconstruction.

20 March 2017 in Chemistry of Materials
Verified
Journal Article
Open access
OBOleksandr V. Bilousov
Oleksandr V. Bilousov
YRYi Ren
Yi Ren
TTTobias Törndahl
Tobias Törndahl
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
TETove Ericson
Tove Ericson
CHCarl Hägglund
Carl Hägglund
Tin monosulfide (SnS) is a promising light-absorbing material with weak environmental constraints for application in thin film solar cells. In this paper, we present low-temperature atomic layer deposition (ALD) of high-purity SnS of both cubic and orthorhombic phases. Using tin(II) 2,4-pentanedionate [Sn(acac)2] and hydrogen sulfide (H2S) as precursors, controlled growth of the two polymorphs is achieved. Quartz crystal microbalance measurements are used to establish saturated conditions and show that the SnS ALD is self-limiting over temperatures from at least 80 to 160 °C. In this temperature window, a stable mass gain of 19 ng cm–2 cycle–1 is observed. The SnS thin film crystal structure and morphology undergo significant changes depending on the conditions. High-resolution transmission electron microscopy and X-ray diffraction demonstrate that fully saturated growth requires a large H2S dose and results in the cubic phase. Smaller H2S doses and higher temperatures favor the orthorhombic phase. The optical properties of the two polymorphs differ significantly, as demonstrated by spectroscopic ellipsometry. The orthorhombic phase displays a wide (0.3–0.4 eV) Urbach tail in the near-infrared region, ascribed to its nanoscale structural disorder and/or to sulfur vacancy-induced gap states. In contrast, the cubic phase is smooth and void-free and shows a well-defined, direct forbidden-type bandgap of 1.64 eV.

1 January 2016 in Solar Energy Materials and Solar Cells
Verified
Journal Article
Open access
JLJohan Lindahl
Johan Lindahl
JKJan Keller
Jan Keller
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
PSPiotr Szaniawski
Piotr Szaniawski
MEMarika Edoff
Marika Edoff
TTTobias Törndahl
Tobias Törndahl
Thin film Cu(In,Ga)Se2 solar cells with ALD-deposited Zn1-xSnxOy buffer layers were fabricated and the solar cell properties were investigated for varying ALD deposition temperatures in the range from 90 °C up to 180 °C. It was found that a process window exists between 105 °C and 135 °C, where high solar cell efficiency can be achieved. At lower ALD deposition temperatures the solar cell performance was mainly limited by low fill factor and at higher temperatures by low open circuit voltage. Numerical simulations and electrical characterization were used to relate the changes in solar cell performance as a function of ALD deposition temperature to changes in the conduction band energy level of the Zn1-xSnxOy buffer layer. The Zn1-xSnxOy films contain small ZnO or ZnO(Sn) crystallites (~10 nm), resulting in quantum confinement effects influencing the optical band gap of the buffer layer. The ALD deposition temperature affects the size of these crystallites and it is concluded that most of the changes in the band gap occur in the conduction band level

17 November 2015 in IEEE Journal of Photovoltaics
Verified
Journal Article
Open access
Bart VermangBart Vermang
Bart Vermang
YRYi Ren
Yi Ren
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
CFChristopher Frisk
Christopher Frisk
JJJonathan Joel
Jonathan Joel
MEMarika Edoff
Marika Edoff
Previously, an innovative way to reduce rear interface recombination in Cu(In,Ga)(S,Se) 2 (CIGSSe) solar cells has been successfully developed. In this work, this concept is established in Cu 2 (Zn,Sn)(S,Se) 4 (CZTSSe) cells to demonstrate its potential for other thin-film technologies. Therefore, ultrathin CZTS cells with an Al 2 O 3 rear surface passivation layer having nanosized point openings are fabricated. The results indicate that introducing such a passivation layer can have a positive impact on open-circuit voltage (V OC ; +17%rel.), short-circuit current (JSC ; +5%rel.), and fill factor (FF; +9%rel.), compared with corresponding unpassivated cells. Hence, a promising efficiency improvement of 32%rel. is obtained for the rear passivated cells.