Klara Kiselman

Klara Kiselman

Auto-generated profile, based on publicly available information

Klara Kiselman

Uppsala University

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 February 2024 in Nature Energy
Verified
Journal Article
Open access
PDF file
JKJan Keller
Jan Keller
KKKlara Kiselman
Klara Kiselman
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
NMNatalia M. Martin
Natalia M. Martin
MBMelike Babucci
Melike Babucci
MEMarika Edoff
Marika Edoff
Chalcopyrite-based solar cells have reached an efficiency of 23.35%, yet further improvements have been challenging. Here we present a 23.64% certified efficiency for a (Ag,Cu)(In,Ga)Se2solar cell, achieved through the implementation of a series of strategies. We introduce a relatively high amount of silver ([Ag]/([Ag] + [Cu]) = 0.19) into the absorber and implement a ‘hockey stick’-like gallium profile with a high concentration of Ga close to the molybdenum back contact and a lower, constant concentration in the region closer to the CdS buffer layer. This kind of elemental profile minimizes lateral and in-depth bandgap fluctuations, reducing losses in open-circuit voltage. In addition, the resulting bandgap energy is close to the local optimum of 1.15 eV. We apply a RbF post-deposition treatment that leads to the formation of a Rb–In–Se phase, probably RbInSe2, passivating the absorber surface. Finally, we discuss future research directions to reach 25% efficiency.

4 May 2025 in Progress in Photovoltaics: Research and Applications
Verified
Journal Article
Open access
KKKlara Kiselman
Klara Kiselman
JKJan Keller
Jan Keller
PPPatrick Pearson
Patrick Pearson
KSKostiantyn Sopiha
Kostiantyn Sopiha
EWErik Wallin
Erik Wallin
MEMarika Edoff
Marika Edoff
Metastable behaviours with respect to light‐soaking of Cu(In,Ga)Se2 (CIGS) solar cells have long been known and studied, but no explanation has yet been fully agreed on. In this study, silver alloying and its impact on light‐soaking effects is explored in four CIGS and six (Ag,Cu)(In,Ga)Se2 (ACIGS) samples with high efficiency (17% to 21% before light‐soaking). All were produced by co‐evaporation and similar depositions protocols as the current world record device but with some variation. A variety of opto‐electronic characterisation methods were used to explore the response to 24 h of light‐soaking at 50°C. We found that (i) the open‐circuit voltage increased for all ACIGS devices but decreased for the CIGS devices, (ii) the cells entered a state with higher doping and more tail states, and (iii) the effect was metastable and partially reverted after dark storage. While the improvement of the ACIGS cells saturates after 24 h in one‐third of the irradiance at one sun, months are needed to reverse the open‐circuit voltage change. Despite a higher doping after light‐soaking, none of the samples' short‐circuit current showed significant changes and the efficiency after light‐soaking ranged from 15% to 22%. No long‐range change in sodium or rubidium distributions was observed using glow‐discharge optical emission spectroscopy. In general, external radiative efficiency measurements showed that the nonradiative recombination loss is reduced after light‐soaking in the ACIGS devices. However, the correlation to the measured voltage was not always straight forward, presumably due to the graded bandgap of the absorber.

1 July 2026 in IEEE Journal of Photovoltaics
Verified
Journal Article
Open access
EBElizaveta Yakovleva Bengtson
Elizaveta Yakovleva Bengtson
AVAndré F. Violas
André F. Violas
ODOlivier Donzel-Gargand
Olivier Donzel-Gargand
KKKlara Kiselman
Klara Kiselman
PPPatrick Pearson
Patrick Pearson
MEMarika Edoff
Marika Edoff