11 May 2025 in Journal of Stomatology Oral and Maxillofacial Surgery
6 February 2024 in Journal of Stomatology Oral and Maxillofacial Surgery
4 November 2025 in Journal of Oral Medicine and Oral Surgery
Introduction: Maxillary sinus floor defects pose a notable challenge in posterior maxillary implant planning due to their complex anatomy and frequent association with insufficient bone volume. This study aimed to evaluate the anatomical characteristics of such defects, introduce a topographic-anatomical classification system, and assess its clinical utility for guiding augmentation techniques and implant timing. Materials and methods: A retrospective cohort study was conducted on 91 patients who underwent evaluation for posterior maxillary implant rehabilitation at Bogomolets National Medical University (2021–2024). Defects were classified based on size, extent, and bony wall integrity. CT data were analyzed using Mimics Medical 23.0 to assess defect area, mesiodistal and vestibulo-oral dimensions, and residual bone height. ANOVA and Kruskal–Wallis tests were used to compare defect types and assess treatment feasibility. Results: Defects varied widely in size and morphology. Type I defects (37.4%) were small and surrounded by four walls, while Type IV (18.6%) were extensive and involved major wall loss. Types I and II could support transcrestal sinus lift and simultaneous implantation, while Types III and IV typically required staged lateral augmentation and additional ridge reconstruction. Residual bone height did not differ significantly across types ( p >0.05), but linear dimensions and area increased progressively ( p <0.001). Conclusion: The proposed classification supports individualized treatment planning by integrating defect dimensions and wall integrity, potentially improving outcomes in posterior maxillary implantology.
16 December 2024 in Journal of Oral Medicine and Oral Surgery
Introduction: This research aimed to study the impact of initial anatomical conditions on decision-making for subantral augmentation in a single tooth gap and to compare the clinical efficiency of closed hydrodynamic sinus lift and lateral sinus floor augmentation (LSFA) for single tooth restoration. Materials and Methods: This retrospective study included 96 patients who underwent subantral augmentation with simultaneous implantation in a single tooth gap. Patients were divided: 50 in the “Open” LSFA group and 46 in the “Closed” hydrodynamic lift group. A two-stage protocol was applied, with data on age, intervention site, implant dimensions, and bone height analyzed. Results: Mean residual bone height differed: 3.341 ± 1.433 mm in “Open” and 4.437 ± 1.741 mm in “Closed” (p = 0.001). Median bone height post-surgery was 9.5 mm in “Open” and 8.5 mm in “Closed” (p = 0.0031), with significant bone height increase (p < 0.00001). No implant or graft removals were needed. Conclusion: Residual alveolar ridge height, cortical bone thickness, and sinus wall thickness are key criteria in selecting a protocol. Both techniques achieved effective results, even with initial bone heights below 5 mm. LSFA led to greater bone height increase, while both approaches provide reliable options for stable implant integration.
26 May 2026 in BMC Oral Health
Background: Reconstruction of short mandibular defects (< 2 cm) remains controversial, as these defects lie within a clinical “gray zone” between spontaneous healing and the need for surgical intervention. In cases of compromised soft tissues, particularly following gunshot injuries, conventional approaches such as bone grafting or microsurgical reconstruction may be suboptimal. This study aimed to evaluate the outcomes of sliding osteotomy (SO) techniques for reconstruction of post-gunshot short mandibular defects. Methods: This prospective case series included 10 patients with post-traumatic gunshot mandibular defects < 2 cm treated with SO techniques between March 2023 and September 2025. Clinical data, surgical characteristics, complications, and prosthetic outcomes were analyzed descriptively. A narrative literature review on SO techniques in mandibular reconstruction was also performed. Results: The mean defect length was 1.29 ± 0.22 cm. Most patients had a history of previous surgical interventions, including prior fracture fixation, failed bone grafting, and debridement. Horizontal SO was performed in 60.0% of cases and sagittal SO in 40.0%. Reconstruction failure due to non-union/fibrous union occurred in 2/10 patients (20.0%). Both patients required secondary mandibular reconstruction with a fibula free flap, which had been completed in one case at the time of evaluation. Conclusions: SO appears to be a technically straightforward option for reconstruction of short mandibular defects, particularly in patients with compromised soft tissue conditions or failed prior grafting. It may represent a salvage alternative within the reconstructive armamentarium for managing small but clinically critical defects. Trial registration: Not applicable. This was an observational prospective case series and did not involve prospective assignment of participants to an intervention.
17 September 2025 in Journal of Oral and Maxillofacial Surgery, Medicine, and Pathology