4 November 2025 in Journal of Oral Medicine and Oral Surgery
Introduction: Maxillary sinus floor defects pose a notable challenge in posterior maxillary implant planning due to their complex anatomy and frequent association with insufficient bone volume. This study aimed to evaluate the anatomical characteristics of such defects, introduce a topographic-anatomical classification system, and assess its clinical utility for guiding augmentation techniques and implant timing. Materials and methods: A retrospective cohort study was conducted on 91 patients who underwent evaluation for posterior maxillary implant rehabilitation at Bogomolets National Medical University (2021–2024). Defects were classified based on size, extent, and bony wall integrity. CT data were analyzed using Mimics Medical 23.0 to assess defect area, mesiodistal and vestibulo-oral dimensions, and residual bone height. ANOVA and Kruskal–Wallis tests were used to compare defect types and assess treatment feasibility. Results: Defects varied widely in size and morphology. Type I defects (37.4%) were small and surrounded by four walls, while Type IV (18.6%) were extensive and involved major wall loss. Types I and II could support transcrestal sinus lift and simultaneous implantation, while Types III and IV typically required staged lateral augmentation and additional ridge reconstruction. Residual bone height did not differ significantly across types ( p >0.05), but linear dimensions and area increased progressively ( p <0.001). Conclusion: The proposed classification supports individualized treatment planning by integrating defect dimensions and wall integrity, potentially improving outcomes in posterior maxillary implantology.
16 December 2024 in Journal of Oral Medicine and Oral Surgery
Introduction: This research aimed to study the impact of initial anatomical conditions on decision-making for subantral augmentation in a single tooth gap and to compare the clinical efficiency of closed hydrodynamic sinus lift and lateral sinus floor augmentation (LSFA) for single tooth restoration. Materials and Methods: This retrospective study included 96 patients who underwent subantral augmentation with simultaneous implantation in a single tooth gap. Patients were divided: 50 in the “Open” LSFA group and 46 in the “Closed” hydrodynamic lift group. A two-stage protocol was applied, with data on age, intervention site, implant dimensions, and bone height analyzed. Results: Mean residual bone height differed: 3.341 ± 1.433 mm in “Open” and 4.437 ± 1.741 mm in “Closed” (p = 0.001). Median bone height post-surgery was 9.5 mm in “Open” and 8.5 mm in “Closed” (p = 0.0031), with significant bone height increase (p < 0.00001). No implant or graft removals were needed. Conclusion: Residual alveolar ridge height, cortical bone thickness, and sinus wall thickness are key criteria in selecting a protocol. Both techniques achieved effective results, even with initial bone heights below 5 mm. LSFA led to greater bone height increase, while both approaches provide reliable options for stable implant integration.