Xuan Wang

Xuan Wang

Auto-generated profile, based on publicly available information

Xuan Wang

Staff Room of Chemistry and Material, Department of Basic Course, Naval University of Engineering, Wuhan 430022, China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 May 2023 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
YLYahao Liu
Yahao Liu
YWYuansheng Wang
Yuansheng Wang
XYXue Yang
Xue Yang
WHWei Huang
Wei Huang
ZYZhang Yu
Zhang Yu
XWXuan Wang
Xuan Wang

16 January 2021 in Complexity
Verified
Journal Article
Open access
PDF file
FYFangyi You
Fangyi You
WZWang Zhou
Wang Zhou
XWXuan Wang
Xuan Wang
QDQiulian Dai
Qiulian Dai
The performance of the grinding wheel demonstrably affects the machining efficiency and the quality of the workpiece. Therefore, it is essential to evaluate the wear of the wheel and then operate the dressing or replacement in time. The wear procession of the wheel was monitored and evaluated systematically in this paper. A surface grinding experiment was performed by using an alumina wheel to grind the workpiece made of Cr12. The grinding force and the grinding temperature were monitored and measured while the wheel grinds the workpiece. The surface topography of the wheel was also being observed. The distribution of the gray value of pixels in the image of the wheel surface was analyzed by the method of the histogram. Processing of the binary image of the wheel was performed after determining the gray threshold of the gray value. Then, the blockading and the wearing area on the grinding wheel were calculated. Moreover, the relation of the projection area of a single abrasive derived from theory and derived by image recognition was studied. The results of the grinding experiment show that wheel performance degradation occurs when the material removal volume reaches 210 mm3/mm. At this time, the ratio of blockage area on the grinding wheel reaches 13.4%. The percentage of the wearing area is 9.5%. The method of image recognition combined with grinding temperature is workable to realize monitoring and evaluating the wear of wheels on site without unloading them.

1 January 2020 in Advanced Composites Letters
Verified
Journal Article
Open access
PDF file
XWXuan Wang
Xuan Wang
FYFangyi You
Fangyi You
JHJian Hong
Jian Hong
WZWang Zhou
Wang Zhou
A device for measuring the depth of the borehole base on the magnetic grid during orthopedic surgery is proposed in this article. It consists of a magnetic grid, winding sleeve, two Hall sensors, and control circuitry. The magnetic grid comprises permanent magnets and coil windings. The device fixes on the electric hand drill and works during the surgical operation. An axial pressure keeps the shaft end of the magnetic grid in contact with the surface of the bone or the plate steadily during the electric handheld drilling of the bone. The pressure is an electromagnetic force generated by the interaction between the permanent magnets and the coil windings. The force should be large enough to support the weight of the magnetic grid and a low fluctuation is maintained. The larger the device, the higher the electromagnetic force will be generated. The electromagnetic force is simulated and obtained with the software of Maxwell. The factors that influence the force were the permanent magnet, and the others are the length of permanent magnet and the turns on the coil. The results of orthogonal simulation show that the primary factor is the diameter of the permanent magnet. The optimized parameters include the following: the diameter of the magnet is 7 mm, length of each permanent magnet is 5 mm, and the turns on the coil are 80. Then the pressure force range is approximately 0.485–0.716 N, and the variance of the force is 0.137.