17 December 2020 in IEEE Transactions on Smart Grid
The declining cost of solar Photovoltaics (PV) generation is driving its worldwide deployment. As conventional generation with large rotating masses is being replaced by renewable energy such as PV, the power system’s inertia will be affected. As a result, the system’s frequency may vary more dramatically in the case of a disturbance, and the frequency nadir may be low enough to trigger protection relays such as under-frequency load shedding. The existing frequency-watt function mandated in power inverters cannot provide grid frequency support in a loss-of-generation event, as PV plants usually do not have power reserves. In this article, a novel adaptive PV frequency control strategy is proposed to reserve the minimum power required for grid frequency support. A machine learning model is trained to predict system frequency response under varying system conditions, and an adaptive allocation of PV headroom reserves is made based on the machine learning model as well as real-time system conditions including inertia. Case studies show the proposed control method meets the frequency nadir requirements using minimal power reserves compared to a fixed headroom control approach.
12 October 2020 in IEEE Open Access Journal of Power and Energy
Novel power system control and new utility devices need to be tested before their actual deployment to the power grid. To assist with such a testing need, real-time digital emulators such as RTDS and Opal-RT can be used to connect to the physical world and form a hardware in the loop (HIL) emulation. However, due to the limitations of today’s computational resources, the accuracy and fidelity suffer from different levels of model reductions in purely digital simulations. CURENT has developed a reconfigurable electric grid hardware testbed (HTB) to overcome the limitations of digital emulators. The HTB has been used to develop measurement, control, modeling, and actuation techniques for a national grid with a high penetration of renewables. The power electronic-based system includes emulators for synchronous generators; photovoltaics with gridinterfacing inverter; wind turbines; induction motor loads, ZIP loads, power electronic loads; batteries; ac and dc transmission lines; short circuit faults and grid relay protection; and a multiterminal HVDC overlay including power electronics interfaces. The system contains real elements of power flow, measurement, communication, protection, and control that mimic what would be seen in an actual electric grid. This paper presents an overview of the HTB and several scenarios that have been run to determine control and actions needed for the future power grid.
17 May 2023 in IEEE Transactions on Smart Grid
The increasing penetration of inverter-based resources (IBRs) calls for an advanced active and reactive power (PQ) control strategy in microgrids. To enhance the controllability and flexibility of the IBRs, this paper proposes an adaptive PQ control method with trajectory tracking capability, combining model-based analysis, physics-informed reinforcement learning (RL), and power hardware-in-the-loop (HIL) experiments. First, model-based analysis proves that there exists an adaptive proportional-integral controller with time-varying gains that can ensure any exponential PQ output trajectory of IBRs. These gains consist of a constant factor and an exponentially decaying factor, which are then obtained using a model-free deep RL approach known as the twin delayed deeper deterministic policy gradient. With the model-based derivation, the learning space of the RL agent is narrowed down from a function space to a real space, which reduces the training complexity significantly. Finally, the proposed method is verified through numerical simulation in MATLAB-Simulink and power HIL experiments in the CURENT center. With the physics-informed learning method, exponential response time constants can be freely assigned to IBRs, and they can follow any predefined trajectory without complicated gain tuning.
1 May 2019 in IEEE Transactions on Industry Applications
Battery energy storage systems (BESSs) tend to be too costly, restrictive, and high-maintenance for experimental use, but power system tests often need their representation. As a solution, we propose an all-in-one, reconfigurable BESS emulation tool for grid applications that only requires one three-phase voltage source converter. This emulator provides chemistry-specific battery behavior like previous work, but it also includes the BESS's power electronics interface and control as well as automatic frequency and voltage support functions for the attached power system. Thus, it allows simple, plug-and-play BESS emulation for grid applications. This paper details the construction, verification, and use of the BESS emulator in an existing grid testbed and concludes that it provides an inexpensive, easy-to-use alternative to using real BESSs in power system experiments.
27 January 2022 in IEEE Transactions on Power Electronics
Data centers have become a widespread power electronics (PE) load, which has significant impact on the power grid. In order to investigate the data center load characteristics, this article proposes a complete dynamic model for a typical data center ac power distribution system. A generalized model with mode transition is proposed to coordinate different power stages in the data center power system. Meanwhile, to help evaluate the grid dynamic performance and transient stability, an all-in-one load data center power emulator is developed on a reconfigurable PE converter-based hardware testbed (HTB). The dynamic power model is digitized and simplified to be implemented in two local voltage source inverters on the HTB. This proposed data center power emulator has been verified experimentally in a regional network. Dynamic performances during voltage sag events and server load variations are emulated and discussed. The article details the design, development, and verification of the data center model and power emulator. The proposed model and emulator provide an effective, easy-to-use tool to better design data centers and study the interaction with the power system.
1 January 2020 in Materials Chemistry and Physics