Neste trabalho foram obtidos nanocompósitos de elastômeros termoplásticos à base de PP/EPDM/argila organofílica pela técnica de intercalação no estado fundido em câmara interna de mistura. Foram preparados concentrados de PP-MA (agente interfacial) e Claytone 40 (argila organofílica) nas proporções de 1:1, 2:1 e 3:1 que posteriormente foram adicionados na matriz PP/EPDM, previamente preparada, mantendo o teor de argila fixo em 5% (em massa). Foram investigadas as propriedades mecânicas de módulo elástico, tração e alongamento na ruptura, reologia e morfologia, a fim de estabelecer a influência da razão PP-MA/argila organofílica no comportamento dos nanocompósitos. Os resultados mostraram que a adição de teores crescentes de PP-MA melhorou a dispersão da argila organofílica na matriz de PP/EPDM. Conforme revelado pela difração de raio X e confirmados pela reometria foram obtidos nanocompósitos com estruturas mistas intercaladas e esfoliadas, que resultaram em maiores valores de módulo e deformação na ruptura.
The use of residual biomass in biocomposite production aligns with environmental goals set by solid waste policies. Starch, a lowcost and renewable natural polymer, often faces challenges with mechanical strength and water vapor permeability. Ucuuba cake, an Amazonian agro-industrial byproduct, offers fiber reinforcement to enhance thermoplastics. Buriti pulp oil, also from the Amazon, acts as a processing aid, improving thermal stability and reducing hydrophilicity. This study explores buriti oil as a partial substitute for glycerol in thermoplastic starch (TPS) biocomposites with ucuuba fibers. Characterization showed that buriti pulp oil, rich in oleic and palmitic acids, enhances hydrophobicity, reducing water absorption. It also lowered final torque during processing, facilitating flow and homogeneity. Mechanical tests indicated a marginal increase in strength but decreased elongation at break. Scanning electron microscopy (SEM) revealed smoother surfaces and better fiber adhesion. Rheological and thermal analyses confirmed the role of buriti pulp oil as a processing aid and thermal stabilizer. This research underscores the potential of renewable resources and industrial residues in sustainable polymer development.
Reducing zinc content in rubber formulations remains an important challenge due to environmental concerns associated with the use of zinc oxide (ZnO) as part of vulcanization systems. Zinc‐containing layered double hydroxides (Zn/Al‐LDHs) offer an alternative approach to incorporating zinc into lamellar structure and have been investigated as both vulcanization activators and fillers. However, the curing behavior of unmodified Zn/Al‐NO 3 LDH in conventional nitrile rubber (NBR) remains insufficiently understood. In this study, Zn/Al‐NO 3 LDH was evaluated as an alternative low‐zinc vulcanization activator for nitrile rubber (NBR) as a replacement for the ZnO/stearic acid system. Conventional (A/S = 0.6) and efficient (A/S = 3.0) sulfur‐curing systems were compared. In the conventional system, the LDH decreased the apparent Ea from 90.81 to 70.95 kJ.mol −1 and reduced the pre‐exponential factor by approximately two orders of magnitude. Tensile strength remained comparable, whereas tear strength decreased by approximately 14%. Thermogravimetric analysis showed a slight increase in the onset degradation temperature for the LDH‐containing formulations. Based on nominal compositions, replacing the ZnO/stearic acid activation system with Zn/Al‐NO 3 LDH corresponded to an estimated 71% reduction in zinc loading. Environmental benefits cannot be inferred from this reduction because zinc release, bioavailability, and ecotoxicological effects were not evaluated.