Rinaldo Castello

Rinaldo Castello

Auto-generated profile, based on publicly available information

Rinaldo Castello

Department of Electrical Computer and Biomedical Engineering, University of Pavia, Pavia, Italy

Research Focus & Metrics

Academic Career Length

35Years (1992-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 April 2020 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
GPGiacomo Pini
Giacomo Pini
DMDanilo Manstretta
Danilo Manstretta
RCRinaldo Castello
Rinaldo Castello
The design of a mixer-first wideband receiver with RF bandwidth of 260 MHz suitable for 5G applications below 6 GHz is presented. The transimpedance amplifier immediately following the passive mixer is based on a low-power modified regulated cascode with enhanced selectivity, instead of a conventional shunt-feedback architecture. At the mixer output, thanks to a positive feedback capacitance multiplication, a third-order low-pass filtering in the current domain is performed. A simplified non-linear model is used to demonstrate that, thanks to the improved selectivity, linearity close to the band edge is highly improved. Wide bandwidth, high linearity, and low power are thus achieved. Measurements on a 28-nm CMOS chip prototype show alternate channel IIP3, IIP2, and P1 dB of +22, +70, and +3 dBm, respectively. Receiver (RX) noise figure (NF) is 5.5 dB, while power consumption is 21.6 mW (in the signal path) and 7.8 mW/GHz (for local oscillator (LO) generation) with 1.8-/1.2-V supply.

18 October 2010 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
LFLuca Fanori
Luca Fanori
ALAntonio Liscidini
Antonio Liscidini
RCRinaldo Castello
Rinaldo Castello
A digitally controlled oscillator (DCO) that achieves a minimum frequency quantization step of 150 Hz without any dithering is presented. The fine digital tuning is obtained through a capacitive degeneration of a portion of the transistor switching pair used in a classical LC-tank oscillator. The new tuning circuitry does not appreciably affect the intrinsic oscillator phase noise and allows to trim the frequency with a programmable resolution for calibration and multi-standard operation. A prototype integrated in 65 nm CMOS technology exhibits a phase noise of @ 1 MHz drawing 16 mA from a supply of 1.8 V, resulting in a FoM of 183 dBc/Hz. The active area is 700 450.

4 December 2017 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
EKEhsan Kargaran
Ehsan Kargaran
DMDanilo Manstretta
Danilo Manstretta
RCRinaldo Castello
Rinaldo Castello
To meet the requirements of wearable wireless sensor networks, the power dissipation of the RF transceiver has to be drastically reduced. This paper presents two ultra-low power low noise amplifiers (LNAs) with RF performance exceeding the requirement of the intended application. In the first LNA, by reusing the current several times and employing passive gm boosting, the LNA input impedance is reduced by a factor of 24 compared with a single transistor using the same current. The feasibility of passive gm boosting for designing an ultra-low supply voltage LNA is also investigated. Limitations of both LNAs, including NF, non-linearity, and stability in a 40-nm CMOS technology are also investigated. The proposed LNAs consume only 30 μW of power, operate with 0.8 V and 0.18 V and show NF of 3.3 and 5.2 dB, respectively. Using a widely accepted figure-of-merit for LNAs, the proposed circuit is almost three times better than the best previously reported sub-mW LNA.

1 May 2018 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
GPGiacomo Pini
Giacomo Pini
DMDanilo Manstretta
Danilo Manstretta
RCRinaldo Castello
Rinaldo Castello
A power-efficient transimpedance amplifier with wide channel bandwidth is proposed to meet the stringent linearity requirements of surface acoustic wave-less frequency-division duplexing receivers. A unity-gain loop bandwidth of 1.6 GHz is achieved with low-power dissipation. This was done without using any internal compensation but relying on zeros, both within the operational transconductance amplifier and in the feedback network, to ensure stability across all parameter variations. A simple non-linear analysis methodology is presented that provides important insights, useful for the design optimization. The prototype, implemented in 28-nm CMOS technology, has 14 dB of gain with 20-MHz bandwidth and achieves 21.1-μV in-band noise together with 33 and 50.5-dBm IIP3 at 6 and 100-MHz offset, respectively, while requiring only 5.4 mW. The corresponding filter figure of merit (FOM) of 183.2 dBJ⁻¹ at 100-MHz offset exceeds that of all previous designs. Simulation shows that an even better FOM could be achieved using a larger width (more linear) feedback resistor. Finally, the differential input impedance is less than 33 Ω at all frequencies.

1 February 1995 in Physics Letters B
Verified
Journal Article
Open access
Maurizio Filippo AcciarriMaurizio Filippo Acciarri
Maurizio Filippo Acciarri
AAA. Adam
A. Adam
OAOscar Adriani
Oscar Adriani
MAM. Aguilar-Benitez
M. Aguilar-Benitez
SASteven Ahlen
Steven Ahlen
BZBob van der Zwaan
Bob van der Zwaan
The production of B∗ mesons in Z decays has been measured at LEP with the L3 detector. A sample of Z → bb events was obtained by tagging muons in 1.6 million hadronic Z decays collected in 1991, 1992 and 1993. A signal with a peak value of Eγ = 46.3 ± 1.9 (stat) MeV in the B rest fram

19 April 2018 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
DMDaniele Montanari
Daniele Montanari
GCGerardo Castellano
Gerardo Castellano
EKEhsan Kargaran
Ehsan Kargaran
GPGiacomo Pini
Giacomo Pini
STSaheed Tijani
Saheed Tijani
RCRinaldo Castello
Rinaldo Castello
Antenna-coupling group delay limits the cancellation bandwidth of conventional self-interference cancellers (SICs), making it difficult to ensure isolation in both transmit (TX) and receive (RX) bands. Isolation over both bands is achieved in the dual-path receiver architecture proposed in this paper. The main path consists of a highly linear current-mode RX with a passive RF SIC. The auxiliary path implements a notch in the TX band followed by an adaptive digital equalizer whose output is used to suppress the TX noise leakage in the RX band. The main and auxiliary receiver prototypes, implemented in 28-nm CMOS technology, operate between 1 and 2 GHz, occupy an area of 0.51 and 0.12 mm 2 , and have a power dissipation of 32-40 and 26-64 mW, respectively. The stand-alone RX has a noise figure (NF) of 4-5 dB and an out-of-band IIP3 of 18 dBm. Turning on the passive canceller results in an effective IIP3 of 25-29 dBm and a degradation of the NF of less than 0.8 dB. Thanks to its high dynamic range, the auxiliary path suppresses the TX noise by >29 dB while degrading the RX NF by only 1 dB at 23-dBm TX output power.