Article provides a brief overview of the complications arising during the construction of oil and gas wells in conditions of abnormally high and abnormally low formation pressures. Technological properties of the solutions used to eliminate emergency situations when drilling wells in the intervals of catastrophic absorption and influx of formation fluid have been investigated. A technology for isolating water influx in intervals of excess formation pressure has been developed. The technology is based on the use of a special device that provides control of the hydrodynamic pressure in the annular space of the well. An experiment was carried out to determine the injection time of a viscoelastic system depending on its rheology, rock properties and technological parameters of the isolation process. A mathematical model based on the use of a special device is presented. The model allows determining the penetration depth of a viscoelastic system to block water-bearing horizons to prevent interformation crossflows and water breakthrough into production wells.
In this work, compositions for isolation of the thief zones are investigated. To define the conditions for polymer application, the kinetics of it’s swelling in different mediums are assessed. Laboratory investigations showed that the swelling property of the reagent depends on the medium pH, which can be used to adjust the dynamics of structure formation in different technological schemes of lost circulation control.
17 October 2026 in International Journal of Engineering
This article presents a comprehensive study of saponite from the Arkhangelsk deposit and its organic modification. The crystal-chemical formula was calculated using chemical and thermogravimetric data. A three-dimensional structural model was constructed using VESTA to visualize the layered structure and cation distribution. Modification with dialkyldimethylammonium chloride (DADMAC) provided the highest hydrophobicity, with a contact angle of up to 87.66°, and the lowest interaction energy with hydrocarbons (0.031 J/m2). The Tanabe method revealed complete suppression of Lewis acid sites and an increase in Brønsted basic sites to 38.1% after DADMAC treatment. Textural analysis showed a significant increase in mesopore content (22.54–22.95%), and NMR spectroscopy revealed distinctive features of DADMAC-induced modification.
17 October 2026 in International Journal of Engineering
The article discusses the development and application of heavy kill fluids (HKF) for well completion and workover operations under conditions of abnormally high formation pressures (AHFP). Particular attention is given to salt-based compositions with densities of 1600, 1800, and 2000 kg/m3, which are designed for use in various climatic environments. Experimental studies were conducted to determine their rheological properties, pH, crystallization temperature, corrosion activity, and contraction behavior when mixed with water and other solutions. It was found that with increasing fluid density, the mass fraction of salts rises, pH decreases, and the corrosion rate at elevated temperatures increases, necessitating the use of corrosion inhibitors. All tested fluids exhibit low crystallization temperatures, which ensures their effective application in winter conditions. The contraction phenomenon˗volume shrinkage upon mixing with water˗was also identified and shown to depend on fluid density and salt concentration. The results obtained make it possible to optimize the composition of HKFs and improve the safety and cost-effectiveness of well completion and workover operations under AHFP conditions.