The energetic igniters through integrating Al/NiO nanolaminates on Cr film bridges have been investigated in this study. The microstructures demonstrate well-defined geometry and sharp interfaces. The depth profiles of the X-ray photoelectron spectroscopy of Al/NiO nanolaminates annealed at 550 °C with a bilayer thickness of 250 nm show that the interdiffusion between the Al layer and NiO layer has happened and the annealing temperature cannot provide enough energy to make the diffusion process much more complete. The electrical explosion characteristics employing a capacitor discharge firing set at the optimized charging voltage of 40 V show that the flame duration time is about 700 μs, and an excellent explosion performance is obtained for (Al/NiO)n/Cr igniters with a bilayer thickness of 1000 nm.
The energetic igniters through integrating B/Ti nano-multilayers on tantalum nitride (TaN) ignition bridge are designed and fabricated. The X-ray diffraction (XRD) and temperature coefficient of resistance (TCR) results show that nitrogen content has a great influence on the crystalline structure and TCR. TaN films under nitrogen ratio of 0.99 % exhibit a near-zero TCR value of approximately 10 ppm/°C. The scanning electron microscopy demonstrates that the layered structure of the B/Ti multilayer films is clearly visible with sharp and smooth interfaces. The electrical explosion characteristics employing a capacitor discharge firing set at the optimized charging voltage of 45 V reveal an excellent explosion performance by (B/Ti) n /TaN integration film bridge with small ignition delay time, high explosion temperature, much more bright flash of light, and much large quantities of the ejected product particles than TaN film bridge.
Integrating energetic materials on a chip has received great attention for its widely potential applications in the microscale energy consumption system, including electric initiation device. In this article, reactive Al/PTFE nanolaminates with periodic layer structure are prepared by magnetron sputtering, which consists of fuel Al, oxidant PTFE, and inert layer Al-F compound in a metastable system. The as-deposited Al/PTFE nanolaminates exhibit a significantly high energy output, and the onset temperature and the heat of reaction are 410 °C and 3034 J/g, respectively. Based on these properties, an integrated film bridge is designed and fabricated via integrating Al/PTFE nanolaminates with a Cu exploding foil, which exhibits enhanced energetic performances with more violent explosion phenomenon, larger quantities of ejected product, and higher plasma temperature in comparison with the Cu film bridge. The kinetic energy of flyers derived from the expansion of the Cu film bridge is also increased around 29.9% via integration with the Al/PTFE nanolaminates. Overall, the energetic performances can be improved substantially through a combination of the chemical reaction of Al/PTFE nanolaminates with the electric explosion of the Cu film bridge.