8 July 2024 in Applied Physics Letters
InGaN-based micro-light-emitting diodes (LEDs) grown on Si have gained tremendous interest for full-color displays. Strain management is a key challenge for the epitaxial growth of InGaN-based long-wavelength LEDs on Si because the accumulated compressive strain can severely limit In incorporation and degrade the quality of InGaN multi-quantum wells (MQWs) when the conventional Al-composition step-graded AlN/AlGaN buffer is used for strain control. In this work, we demonstrate a promising approach to effectively reduce the in-plane residual compressive stress of GaN by using an AlN single-layer buffer. The in-plane lattice parameter of the GaN underlayer was increased from 3.183 to 3.189 Å with the residual compressive stress at room temperature reduced from 0.37 to ∼0 GPa, which significantly improved the In incorporation of InGaN MQWs and extended the photoluminescence wavelength from 510 to 550 nm. A remarkably high internal quantum efficiency of 78% was thus achieved for the as-grown InGaN-based green LEDs on Si. This work paves the way for the growth of high-efficiency InGaN-based long-wavelength micro-LEDs.
12 April 2019 in Japanese Journal of Applied Physics
The room temperature photoluminescence (PL) intensity of In
x
Ga
1-
x
N/In
y
Ga
1-
y
N multiple quantum wells were correlated with the structural properties such as polarization strength and ground-state quantum levels for the triangular quantum wells. For x – y ≤ 0.2, the PL intensity increased with increasing the In-content of the well. In this region, we found that the PL intensity can be well described by the thermionic emission process with an activation energy corresponding to the energy difference between the valence band of barrier and the quantum level of holes in the well at the well/barrier interface. The pre-factor of the exponential component of effective barrier, reflecting the effective density of nonradiative recombination centers in the barriers, was 3.7 times larger for the samples with GaN barriers than that with InGaN barriers, indicating that the PL intensity is also influenced by the optical quality of barriers when the effective barrier height is relatively low.
12 February 2025 in Journal of Applied Physics
For AlGaN-based near ultraviolet laser diodes (UVA LDs) with emission wavelength below 365 nm, there is no such suitable substrate for homoepitaxy to the required AlGaN films. In this study, we proposed a two-step growth (TSG) method of thick Al0.2Ga0.8N layer grown on the sapphire substrate with a sputtered AlN nucleation layer. The influence of growth rate and V/III ratio on the growth mode of an AlGaN layer has been studied in detail. It is found that AlGaN films exhibit larger island size and lower island density with low growth rate and low V/III ratio during the 3D growth stage, which can effectively relax the compressive stress and suppress the dislocation formation of the subsequent thick AlGaN layer. Therefore, a crack-free high-quality 5 μm-thick Al0.2Ga0.8N layer with 85% biaxial relaxation is grown on a sapphire substrate by using the TSG method, revealing the threading dislocation density decreases from 1.2 × 1010 to 6.6 × 108 cm−2. This work paves the way for the realization and improvement of high-performance AlGaN-based UVA emitters.
1 January 1996 in Transactions of the Society of Instrument and Control Engineers