Hui-Jie Yan

Hui-Jie Yan

Auto-generated profile, based on publicly available information

Hui-Jie Yan

Key Laboratory of Materials Modification by Laser, Ion, and Electron Beams of the Ministry of Education, School of Physics, Dalian University of Technology

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2022 in Plasma Sources Science and Technology
Verified
Journal Article
Closed access
TLTing Li
Ting Li
HYHui-Jie Yan
Hui-Jie Yan
JLJia-Qi Li
Jia-Qi Li
JSJ Schulze
J Schulze
SYSi-Qi Yu
Si-Qi Yu
QZQuanzhi Zhang
Quanzhi Zhang
The charge accumulation and decay in surface dielectric barrier discharges (SDBDs) driven by a sine AC voltage waveform (4 kHz) in combination with a nanosecond positive voltage pulse (300 ns, 20 Hz) is experimentally investigated based on a combination of the electro-optical Pockels effect and a high-speed camera. It is found that the accumulation of positive surface charge on the dielectric promotes the discharge in the negative half cycle of the applied AC voltage, whereas it inhibits the development of following new positive charge filaments. The decay of a single positive charge filament on the surface is a result of the neutralization by negative charges that originate either from the migration of negative surface charge (electrons) or the drift of free electrons from the volume above the surface towards the surface. This work aims to contribute to a better understanding of the evolution of surface charge and its effects in SDBDs.

1 July 2021 in Plasma Sources Science and Technology
Verified
Journal Article
Closed access
PDF file
YWYu-Ying Wang
Yu-Ying Wang
HYHui-Jie Yan
Hui-Jie Yan
HGHong-Fei Guo
Hong-Fei Guo
YXYong-Feng Xu
Yong-Feng Xu
QZQuan-Zhi Zhang
Quan-Zhi Zhang
JSJian Song
Jian Song
The time evolution of dielectric barrier discharge driven by nanosecond pulse high-voltage power is investigated by high-speed video analysis, electrical measurements and spectral diagnostics. It is found that the discharge mode generally goes through the evolution process of filamentary discharge → diffuse discharge → filamentary discharge with the increase in discharge cycle. The time-dependent changes in the standard deviation of image gray levels indicate that the discharge uniformity first improves and then deteriorates in this evolution process. The different pre-ionization density and modulated distribution of space charges and surface charges are considered to be the main reasons for the time evolution of discharge uniformity. In addition, the experiments under different frequencies and voltages show that the transition of the discharge mode is more likely to occur at higher frequency and higher voltage. Further measurement and calculation reveal that the discharge at high frequency and high voltage has the same characteristics, that is, high pre-ionization degree, thick filament diameter and short time lag. These characteristics usually lead to higher seed electron density, larger critical avalanche size and weaker lateral inhibition effect, which make the discharge mode transition more likely to occur.

1 February 2023 in Journal of Physics D: Applied Physics
Verified
Journal Article
Closed access
PDF file
YWYue Wu
Yue Wu
SLShou-Zhe Li
Shou-Zhe Li
YNYu-Long Niu
Yu-Long Niu
HYHui-Jie Yan
Hui-Jie Yan
Dezheng YangDezheng Yang
Dezheng Yang
JZJialiang Zhang
Jialiang Zhang
An atmospheric-pressure microwave plasma torch (APMPT) is employed to drive Boudouard reaction [C(s) + CO2(g) → 2CO(g)] to convert CO2 into CO with storable chemical energy. In this experiment, the solid carbon is placed in the downstream of the afterglow of carbon dioxide APMPT, which is enclosed in reaction chamber, thereby the reaction occurs in the environment with a plenty of the active species and the large enthalpy. The conversion and energy efficiency are experimentally determined by measuring the change of the gas composition, which is analyzed with a Fourier transformation infrared spectrometer and gas chromatograph. The variations of conversion and energy efficiency are investigated with respect to the plasma state, which is tuned by changing microwave power, gas flow rate, and Ar-CO2 mixture ratio, and the different forms of carbon material. And the high conversion efficiency is obtained with use of the herbaceous type of biomass as carbon material and by increasing microwave power, however, the large percentage of CO2 in carrier gas and increasing gas flow rate impose a negative influence on CO2 conversion.

17 October 2022 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
TLTing Li
Ting Li
HYHui-Jie Yan
Hui-Jie Yan
SYSi-Qi Yu
Si-Qi Yu
YWYu-Ying Wang
Yu-Ying Wang
JLJia-Qi Li
Jia-Qi Li
QZQuanzhi Zhang
Quanzhi Zhang
The surface charge distribution in a surface dielectric barrier discharge driven by repetitive pulse bias superimposed on AC voltage is measured using the Pockels effect of an electro-optic crystal. The impact of surface charge on surface-breakdown characteristics is investigated by varying the phase of the pulse superimposition. It is demonstrated that the surface charge accumulation varies at different superimposition phases depending on the potential difference between the two electrodes. The accumulated positive/negative surface charge will facilitate the following surface discharge when the AC voltage polarity changes. In addition, different spatiotemporal characteristics of the surface charge distribution are presented when changing the polarity of superimposed pulses. Positive surface discharges are usually easier to develop than negative surface discharges due to their lower breakdown voltage caused by the accumulation of negative surface charges near the edges of exposed electrodes. The decay of positive surface charge is dominated by neutralization of negative surface charge and negatively charged particles (free electrons and negative ions) from the volume above the dielectric. There are two decay modes of positive surface charge: exponential decay and linear decay.

1 February 2018 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
YLYidi Liu
Yidi Liu
HYHuijie Yan
Huijie Yan
HGHongfei Guo
Hongfei Guo
ZFZhihui Fan
Zhihui Fan
YWYuying Wang
Yuying Wang
CRChunsheng Ren
Chunsheng Ren
The effects of a parallel magnetic field on the unipolar positive nanosecond pulsed dielectric barrier discharge are experimentally investigated through electrical and spectral measurements. The discharge is produced between two parallel-plate electrodes in the ambient air with a parallel magnetic field of 1.4 T. Experimental results show that both the discharge intensity and uniformity are improved in the discharge with the parallel magnetic field. The intensity ratio of the spectrum at 371.1 nm and 380.5 nm, which describes the average electron density, is increased by the parallel magnetic field. Meanwhile, the intensity ratio of the spectrum at 391.4 nm and 337.1 nm, which describes the electron temperature, is also increased. It is speculated that both the average electron density and the electron temperature are increased by the parallel magnetic field. The aforementioned phenomena have been explained by the confinement effect of the parallel magnetic field on the electrons.

4 January 2023 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
HYHuijie Yan
Huijie Yan
NBNicolas Benard
Nicolas Benard
EMEric Moreau
Eric Moreau
This experimental study aims to better understand the electrical and optical properties of a positive DC corona discharge and to highlight the influence of applied voltage and electrode gap on the discharge regime. When the high voltage is increased, three successive regimes have been observed, including one that has never been reported in the literature to the best of our knowledge. This is certainly due to the fact that the tungsten needle used in these experiments is a commercial needle, with a tip of perfect surface finish. In fact, after the ignition voltage, the mean current slowly increases, and it perfectly follows the theoretical Townsend's law; this is the glow regime. When the voltage reaches a first threshold, a few small current pulses appear. However, this is not the breakdown streamer regime because photographs and intensified camera visualizations highlight that the propagation of streamers toward the grounded plate is limited to half of the gap. In this regime, the time-averaged current becomes higher than that of Townsend's law. Each current pulse is composed of only one bump, and the pulse frequency is higher (approximately 20 kHz) than that of the breakdown streamers. When the voltage reaches a second threshold, the magnitude of current pulses suddenly increases, but their frequency decreases (a few kHz); this is the transition toward the breakdown streamer regime. In this regime, each current pulse is composed of two bumps: the first one corresponds to the arrival of a primary streamer at the plate and the second one corresponds to a secondary streamer. Finally, we investigated the effects of the electrode gap. The magnitude and frequency of the current pulses increase when the gap decreases. Consequently, the offset between Townsend's curve and the experimental I–V characteristics increases when the gap decreases, because the pulse component of the total discharge current increases.