1 May 2022 in Plasma Sources Science and Technology
The charge accumulation and decay in surface dielectric barrier discharges (SDBDs) driven by a sine AC voltage waveform (4 kHz) in combination with a nanosecond positive voltage pulse (300 ns, 20 Hz) is experimentally investigated based on a combination of the electro-optical Pockels effect and a high-speed camera. It is found that the accumulation of positive surface charge on the dielectric promotes the discharge in the negative half cycle of the applied AC voltage, whereas it inhibits the development of following new positive charge filaments. The decay of a single positive charge filament on the surface is a result of the neutralization by negative charges that originate either from the migration of negative surface charge (electrons) or the drift of free electrons from the volume above the surface towards the surface. This work aims to contribute to a better understanding of the evolution of surface charge and its effects in SDBDs.
17 October 2022 in Journal of Applied Physics
The surface charge distribution in a surface dielectric barrier discharge driven by repetitive pulse bias superimposed on AC voltage is measured using the Pockels effect of an electro-optic crystal. The impact of surface charge on surface-breakdown characteristics is investigated by varying the phase of the pulse superimposition. It is demonstrated that the surface charge accumulation varies at different superimposition phases depending on the potential difference between the two electrodes. The accumulated positive/negative surface charge will facilitate the following surface discharge when the AC voltage polarity changes. In addition, different spatiotemporal characteristics of the surface charge distribution are presented when changing the polarity of superimposed pulses. Positive surface discharges are usually easier to develop than negative surface discharges due to their lower breakdown voltage caused by the accumulation of negative surface charges near the edges of exposed electrodes. The decay of positive surface charge is dominated by neutralization of negative surface charge and negatively charged particles (free electrons and negative ions) from the volume above the dielectric. There are two decay modes of positive surface charge: exponential decay and linear decay.
8 February 2023 in Journal of Applied Physics
The influence of the cylindrical exposed electrode diameter on distribution and attenuation of the surface charge in surface dielectric barrier discharges is experimentally investigated using the Pockels effect of the Bi12SiO20 crystal. For the actuator with the smaller exposed electrode diameter, more positive charges accumulate closer to the exposed electrode after positive half periodic discharge, while the quantity of positive charges deposited on the surface in a discharge period at the same distance away from the exposed electrode is smaller. At the same time, the smaller the exposed electrode diameter is, the shorter decay time the positive charge filament needs. Combined with thrust generation of actuators, it can be indicated that a positive residual surface charge closer to the exposed electrode may play a more crucial role in the discharge and consequent thrust than one far away from the exposed electrode does. Also, the effect on the discharge of the positive residual surface charge may be greater than that of the negative residual surface charge. More explorations of the residual surface charge have been done by selectively enhancing the discharge of the actuator with a 10 μm exposed electrode using the pulse-AC dual power supply, drawing the same conclusions.
21 December 2021 in Journal of Physics D: Applied Physics
The evolution of surface charge in surface dielectric barrier discharge (SDBD) is observed by using Pockels effect. SDBD is driven by sine AC and pulse dual-power supply voltage. The filamentary discharge and glow-like discharge are enhanced by superimposing positive pulse on sine trough and negative pulse on sine crest, respectively. The interval of enhanced discharge is adjusted by pulse repetition frequency (PRF). The formation and decay of surface charges are analyzed at low PRF, and the accumulation effect is analyzed at high PRF. The results showed that the decay rates of charges decrease with increasing distance from the exposed electrode. When a positive pulse is superimposed on sine trough, the traces of positive charges are filaments with long extending lengths, which are the footprints of discharge channels. The lifetime of positive charges is hundreds of AC cycles (tens of milliseconds). Under certain conditions, subsequent glow-like discharge evolves as ‘flying’ above the dielectric surface (three-dimensional (3D) propagation). Most of the negative charges are neutralized in subsequent filamentary discharge. Some negative charges accumulate downstream and exist longer than positive charges. In the case of negative pulses superimposed on sine crest, the enhanced glow-like discharge appears 3D propagation. The propagation distance is much smaller than that of positive pulse. Most of the negative charges are uniformly distributed near the exposed electrodes with a short lifetime (a few hundred microseconds) and are quickly neutralized in subsequent discharges. The occurrence of 3D propagation requires certain conditions and the mechanism needs further research.
24 August 2023 in Plasma Processes and Polymers
16 February 2023 in Journal of Physics D: Applied Physics
The surface charges in nanosecond pulsed dielectric barrier discharge under quiescent air and airflow are detected based on the Pockels effect of electro-optical crystals. In quiescent air, it is found that the surface charge spot propagates and moves in a certain direction due to the combination of the transverse electric field and the thermal accumulation during dozens of consecutive discharge cycles. However, the position of the surface charge spot remains fixed throughout a single discharge cycle (0.83 ms). At the same time, the noticeable decay of surface charges emerges in the above time scales. Furthermore, when the airflow is introduced into the discharge gap, the propagation and movement of surface charges are accelerated. With the increase of airflow velocity, the discharge transforms from a filamentary mode to a diffuse mode, and the distribution of surface charges varies from discrete to uniform. The transition point of the discharge state and charge distribution corresponds to the airflow velocity of 10 m s−1. The airflow accelerates the decay of surface charges, resulting in the shrink and dispersion of surface charges, which is considered to be the fundamental reason for the airflow’s potential to improve discharge uniformity. The inherent mechanism for achieving uniform discharge is revealed in this study.