The alloy powder and SiCw reinforcement were ball milled, cold-pressed, sintered, hot extruded and solution aged to obtain excellent mechanical properties such as hardness and compressive strength. The microstructure and properties of the material were characterized by metallographic microscope, scanning electron microscope (SEM), EDS, X-ray diffraction (XRD), HV-1000 microhardness and 7051 eddy current conductivity. The results show that the distribution of SiC whiskers in the mixed powder is relatively uniform, but there is still a small amount of agglomeration phenomenon in the sintered sample. The optimum cold pressure is 740 MPa. With the increase in SiCw content, the hardness, dislocation density and compressive strength of aluminum matrix composites are improved. The compressive strength of 5%SiCw reinforced aluminum matrix composite is 658.9 MPa and the elongation is 6.7%.
Al-Zn-Mg-Cu extruded aluminum alloy was processed by multistage solid solution aging process to obtain excellent mechanical properties.Such as Strength, plasticity, corrosion resistance,and the microstructure and properties of the materials were characterized by metallographic microscope,XRD,hv-1000 microhardness tester and wdw-200 microcomputer controlled universal testing machine.The experimental results show that the aging temperature T7X-1 has lower strength but higher plasticity compared with T6.With the increase of the solid solution temperature, the strength showed a certain regularity, the maximum tensile strength of the alloy can reach 787.1 MPa.The multi-stage solid solution process can increase the dislocation density and improve the intergranular corrosion resistance of the alloy.And by comparison, the alloy in the solution treatment system (460 ℃×2 h+470 ℃×2 h+480 ℃×2 h and aging system(121 ℃×5 h+153 ℃×16 h) heat treatment state has a good comprehensive mechanical properties.
In this paper, Al-11.1Zn-2.7Mg-1.7Cu-1.4Ti-0.2Zr alloy material was prepared by powder metallurgy to study the effect of the different solid-solution aging systems on the microstructure and mechanical properties of this 7000 series aluminum alloy. The microstructure of the alloy under the three different solid-solution processes S1, S2, and S3 were observed using an optical microscope, scanning electron microscope, and X-ray diffraction analysis. The mechanical properties were tested to determine the best solid-solution process. The results show that under the S2 solid-solution process, the alloy has the best mechanical properties, with a compressive strength of 646.7(±6.5) MPa and a fracture strain of 5.9(±0.06)%. The maximum hardness trends in the three solid-solution processes after aging are S2>S3>S1. The maximum hardness 220.7(±5.5 )HV occurs after S2 solid-solution and 121℃×18 h aging. Moreover, after S2 solid-solution treatment, the solid-solution degree is close to saturation, the solid-solution strengthening effect is the best, and dislocations contribute the most to the strength.