This study describes a sputtered scandium aluminum nitride (ScAlN) thin-film bulk acoustic resonator (FBAR) at 55.4 GHz. The resonator leverages the third-order symmetric (S3) mode in 37 nm Al on 85 nm Sc 0.3 Al 0.7 N on a 37 nm Al film stack, enabled by a new fabrication procedure. The 55.4 GHz S3 tone achieves electromechanical coupling (k 2 ) of 3.8% and a 3-dB quality factor (Q) of 30, surpassing the reported state-of-the-art figure of merits (FoM, k 2 ∙Q). Besides, the first-order symmetric (S1) mode at 21.0 GHz achieves k 2 of 6.4% and Q of 62. Upon further optimization of the sputtering procedure, ScAlN/AlN-based mmWave acoustic resonators will continue to be improved.
11 April 2023 in Mechanical Systems and Signal Processing
Diamond has been demonstrated as an exceptional semiconductor for microelectromechanical system (MEMS) sensors, offering high sensitivity and reliability due to its ultra-wide bandgap energy, superior mechanical properties, and high thermal conductivity. For MEMS resonator-type sensors that rely on frequency shift detection, such as mass sensors, the overall performance, including the sensitivity, speed, resolution, and noise level, is collectively determined by the stability of the resonance frequency. To improve the sensing performance, geometry optimization and nonlinear operation methods have been used, but these methods lead to increased fabrication complexity or increased energy dissipation. In this work, we propose the utilization of high-order resonance modes to enhance the resonance frequency stability of single-crystal diamond (SCD) MEMS resonators, achieving a significant improvement in mass resolution to as low as 0.15 atto-grams at room temperature. This approach offers a streamlined and competitive strategy for advancing the sensing capabilities of MEMS sensors.
To understand the nonlinear dynamic mechanism of a rotor-bearing system coupled with air bag and floating-raft, the dynamic characteristics of the system are investigated. This work has two key objectives. First, the vibration mechanism of rotor-bearing system coupled with air bag and floating-raft is investigated by developing a numerical model. Then, the nonlinear dynamics of the system and the effect of several parameters are studied, which includes the steady-state response and its spectrum, the orbit and its Poincaré map, the bifurcation diagram, and largest Lyapunov exponent (LLE). The results show that at low speed the dynamic behavior appears in a single periodic motion, and, with the increase of the speed, the motion becomes quasi-periodic and chaotic. These performances indicate that the air bag and floating-raft introduce some dynamic effects of marine rotor-bearing system.
We present a highly sensitive multi-parameter sensor for magnetic and gas detection. The device is based on an in-plane doubly clamped micro-beam micro-resonator, which is electrothermally heated. It acts as a Lorentz force magnetic sensor of high sensitivity, good linearity, good repeatability, and low hysteresis effect. It also functions as a gas-sensor based on the cooling/heating effect of the micro-beam as demonstrated for carbon dioxide (CO2) and methane (CH4) detection. The CO2/CH4 sensor shows high sensitivity and excellent linearity. In addition, we demonstrate simultaneous magnetic and gas detection by tracking the frequency shift of the first two symmetric and anti-symmetric modes at the same time. We show that the sensitivity of the magnetometer is gas-independent and only depends on the frequency shift of the second mode, which is unaffected by variations of the thermal axial load. For the first time, high sensitivity to magnetic fields, CO2, and CH4 is demonstrated using the same device. The demonstrated simultaneous and highly-sensitive multi-parameter sensing platform using a single resonator is promising for smart environmental and monitoring applications.