1 June 2022 in Journal of Advanced Transportation
A plug-in hybrid electric vehicles (PHEV) charger adapter consists of an AC/DC power factor correction (PFC) circuit accompanied by a full-bridge isolated DC/DC converter. This paper introduces an efficient two-stage charger topology with an improved PFC rectifier as front-end and a high-frequency zero voltage switching (ZVS). Current switching (ZCS) DC/DC converter is the second part. The front-end converter is chosen as bridgeless interleaved (BLIL) boost converter, as it provides the advantages like lessened input current ripple, capacitor voltage ripple, and electromagnetic interference. Resettable integrator (RI) control technique is employed for PFC and DC voltage regulation. The controller achieves nonlinear switching converter control and makes it more resilient with the faster transient response and input noise rejection. The second stage incorporates a resonant circuit, which helps in achieving ZVS/ZCS for inverter switches and rectifier diodes. PI controller with phase shift modulator is used for second-stage converter. It improves the overall efficacy of the charger by lowering the switching losses, lowering the voltage stress on the power semiconductor devices, and reversing recovery losses of the diodes. The simulations and experimental results infer that the overall charging efficiency increases to 96.5%, which is 3% higher than the conventional two-stage approach using the interleaved converter.
1 June 2017 in Energy Procedia
19 January 2025 in Results in Engineering
2 January 2018 in IETE Journal of Research
In this paper, a new semi-bridgeless interleaved (SBLIL) boost rectifier topology as front end converter for plug-in hybrid electric vehicle (PHEV) is proposed. The proposed rectifier topology achieves higher efficiency, with high input power factor and less power drawn from the utility. A detailed principle of operation and analytical modelling of the converter is presented. The converter prototype is designed for 300 W with a high switching frequency of 80 kHz and tested for a universal input voltage of (110–240) V to get the desired output voltage of 400 V. The modified converter topology achieves a high efficiency of 97% as it eliminates the bridge rectifier and addition of slow diodes. The performance of the proposed converter is compared with the existing standard topologies. The experimental results infer that the power factor at the supply end is 0.99 with THD less than 5% when the load is varied from half load to full load condition.
1 December 2017 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This paper proposes a non-isolated soft-switching bidirectional dc/dc converter for interfacing energy storage in DC microgrid. The proposed converter employs a half-bridge boost converter at input port followed by a LCC resonant tank to assist in soft-switching of switches and diodes, and finally a voltage doubler circuit at the output port to enhance the voltage gain by two times. The LCC resonant circuit also adds a suitable voltage gain to the converter. Therefore, overall high voltage gain of the converter is obtained without a transformer or large number of multiplier circuit. For operation in buck mode, the high side voltage is divided by half with capacitive divider to gain higher step-down ratio. The converter is operated at high frequency to obtain low output voltage ripple, reduced magnetics and filters. Zero voltage turn-on is achieved for all switches and zero current turn-on and turn-off is achieved for all diodes in both modes i.e., buck/boost operation. Voltage stress across switches and diode is clamped naturally without external snubber circuit. An experimental prototype has been designed, built and tested in the laboratory to verify the performance of the proposed converter.