Recently, titanium oxide has been widely investigated as a carrier-selective contact material for silicon solar cells. Herein, titanium oxide films were fabricated via simple deposition methods involving thermal evaporation and oxidation. This study focuses on characterizing an electron-selective passivated contact layer with this oxidized method. Subsequently, the SiO2/TiO2 stack was examined using high-resolution transmission electron microscopy. The phase and chemical composition of the titanium oxide films were analyzed using X-ray diffraction and X-ray photoelectron spectroscopy, respectively. The passivation quality of each layer was confirmed by measuring the carrier lifetime using quasi-steady-state photoconductance, providing an implied open circuit voltage of 644 mV. UV–vis spectroscopy and UV photoelectron spectroscopy analyses demonstrated the band alignment and carrier selectivity of the TiO2 layers. Band offsets of ~0.33 and ~2.6 eV relative to the conduction and valence bands, respectively, were confirmed for titanium oxide and the silicon interface.
8 February 2023 in Solar Energy Materials and Solar Cells
Monolithic perovskite–silicon tandem solar cells with MoOx hole selective contact silicon bottom solar cells show a power conversion efficiency of 8%. A thin 15 nm-thick MoOx contact to n-type Si was used instead of a standard p+ emitter to collect holes and the SiOx/n+ poly-Si structure was deposited on the other side of the device for direct tunneling of electrons and this silicon bottom cell structure shows ~15% of power conversion efficiency. With this bottom carrier selective silicon cell, tin oxide, and subsequent perovskite structure were deposited to fabricate monolithic tandem solar cells. Monolithic tandem structure without ITO interlayer was also compared to confirm the role of MoOx in tandem cells and this tandem structure shows the power conversion efficiency of 3.3%. This research has confirmed that the MoOx layer simultaneously acts as a passivation layer and a hole collecting layer in this tandem structure.
23 April 2024 in Process Integration and Optimization for Sustainability
Photovoltaic (PV) installations have traditionally relied on a conventional south-facing orientation, which maximizes energy production at noon but has lower energy generation in the morning and afternoon. Vertical photovoltaic (VPV) systems have emerged as promising alternatives to address this inconsistency. Vertical photovoltaic systems can enhance energy generation by facing east in the morning and west in the afternoon. We compared the performance of n-tunnel oxide passivated contact (n-TOPCon) and p-passivated emitter and rear contact (p-PERC) cells in vertical photovoltaic systems to determine whether the optimal installation direction of bifacial vertical photovoltaics is east or west. Our findings indicated that n-TOPCon cells exhibited higher energy yields than p-PERC cells, with a difference of approximately 8%, attributed to the superior bifaciality and lower temperature coefficient of power of n-TOPCon. Additionally, the energy yield was higher for n-TOPCon modules when the front faced east, whereas the PERC modules performed better with a west-facing front. This contributes to the knowledge of the factors for energy production in vertical photovoltaic systems and the optimization of installation configurations.
26 February 2022 in Solar Energy Materials and Solar Cells