This work presents the fabrication and performance analysis of a novel enhancement-mode (E-mode) vertical β-Ga2O3 (010) U-trench MOSFET featuring an in-situ Mg-doped current blocking layer (CBL) for high-power applications. Utilizing metal-organic chemical vapor deposition (MOCVD), we achieved precise Mg doping of 1.3×1019 cm−3 within the CBL to enhance current blocking capability while maintaining a robust threshold voltage of 5 V and a low on-state resistance of 5 mΩ .cm2. The device achieved an on-current of 1.56 kA/cm2 at VGS = 20 V and VDS = 40 V. The fabricated devices demonstrate a peak breakdown voltage of 101 V with an average breakdown field strength of up to 1.68 MV.cm−1. The calculated power device Figure of Merit is 2 MW.cm−2.
Si-doped β-phase (010) Ga2O3 epi-films with fast growth rates were comprehensively investigated using trimethylgallium (TMGa) as the Ga precursor via metalorganic chemical vapor deposition (MOCVD). Two main challenges facing the MOCVD growth of thick (010) β-Ga2O3 films with fast growth rates include high impurity carbon (C) incorporation and rough surface morphologies due to the formation of imbedded 3D pyramid-shaped structures. In this work, two different categories of oxygen source (high-purity O2 > 99.9999% and O2* with 10 ppm of [H2O]) were used for β-Ga2O3 MOCVD growth. Our study revealed that the size and density of the 3D defects in the β-Ga2O3 epi-films were significantly reduced when the O2* was used. In addition, the use of off-axis (010) Ga2O3 substrates with 2° off-cut angle leads to further reduction of defect formation in β-Ga2O3 with fast growth rates. To suppress C incorporation in MOCVD β-Ga2O3 grown with high TMGa flow rates, our findings indicate that high O2 (or O2*) flow rates are essential. Superior room temperature electron mobilities as high as 110–190 cm2/V·s were achieved for β-Ga2O3 grown using O2* (2000 sccm) with a growth rate of 4.5 μm/h (film thickness of 6.3 μm) within the doping range of 1.3 × 1018–7 × 1015 cm−3. The C incorporation is significantly suppressed from ∼1018 cm−3 to <5 × 1016 cm−3 ([C] detection limit) for β-Ga2O3 grown using high O2 (O2*) flow rate of 2000 sccm. Results from this work will provide guidance on developing high-quality, thick β-Ga2O3 films required for high power electronic devices with vertical configurations.
This Letter reports a highly scaled 90 nm gate length β-Ga2O3 (Ga2O3) T-gate MOSFET with a power gain cutoff frequency (fMAX) of 55 GHz. The 60 nm thin epitaxial Ga2O3 channel layer was grown by molecular beam epitaxy, while the highly doped (n++) source/drain regions were regrown using metal organic chemical vapor deposition. Maximum on current (IDS,MAX) of 160 mA/mm and trans-conductance (gm) around 36 mS/mm were measured at VDS = 10 V for LSD = 1.5 μm device. Transconductance and on current are limited by high channel sheet resistance (Rsheet). Gate/drain breakdown voltage of 125 V was measured for LGD = 1.2 μm. We extracted 27 GHz current gain cutoff frequency (fT) and 55 GHz fMAX for 20 V drain bias for unpassivated devices. While no current collapse was seen initially for both drain and gate lag measurements for 500 ns pulse, moderate current collapse was observed after DC, RF measurements caused by electrical stressing. We calculated a high fT. VBR product of 3.375 THz V, which is comparable to the state-of-the-art GaN HEMTs. This figure of merit suggests that Ga2O3 could be a potential candidate for X-band application.
1 July 2024 in Journal of Vacuum Science & Technology A
We report on the growth of Si-doped homoepitaxial β-Ga2O3 thin films on (010) Ga2O3 substrates via metal-organic chemical vapor deposition (MOCVD) utilizing triethylgallium (TEGa) and trimethylgallium (TMGa) precursors. The epitaxial growth achieved an impressive 9.5 μm thickness at 3 μm/h using TMGa, a significant advance in material growth for electronic device fabrication. This paper systematically studies the Schottky barrier diodes fabricated on the three MOCVD-grown films, each exhibiting variations in the epilayer thickness, doping levels, and growth rates. The diode from the 2 μm thick Ga2O3 epilayer with TEGa precursor demonstrates promising forward current densities, the lowest specific on-resistance, and the lowest ideality factor, endorsing TEGa’s potential for MOCVD growth. Conversely, the diode from the 9.5 μm thick Ga2O3 layer with TMGa precursor exhibits excellent characteristics in terms of lowest leakage current, highest on-off ratio, and highest reverse breakdown voltage of −510 V without any electric field management, emphasizing TMGa’s suitability for achieving high growth rates in Ga2O3 epilayers for vertical power electronic devices.
Ultrawide bandgap (UWBG) semiconductor β-phase Ga2O3 has attracted significant interest for potential power electronics applications. This, however, is hindered by the lack of effective p-type dopants in β-Ga2O3. A p–n heterojunction utilizing the recently discovered UWBG p-type LiGa5O8 in conjunction with n-type (010) β-Ga2O3 is demonstrated in this work. Ohmic contacts to the UWBG p-type material, LiGa5O8, were achieved via a combinational Pt/Ni/Au metal stack. Obvious improvement in contact resistance was observed with annealing of the contact metal at 375 °C for 1 min in N2 ambient. Rectifying characteristics with a turn-on voltage of 5.46 V and an ideality factor of 2.78 were extracted from the p-LiGa5O8/n-Ga2O3 heterojunction. Current density change of more than 7 orders of magnitude was obtained between the off-state and on-state of the diodes measured. This work provides a potential pathway to fully utilize the high breakdown field associated with β-Ga2O3 for high power device applications with a p-type material that has an even wider bandgap (and therefore a potentially higher breakdown field) than β-Ga2O3.
This study investigates the electrical and structural properties of metal–oxide–semiconductor capacitors (MOSCAPs) with in situ metal-organic chemical vapor deposition-grown Al2O3 dielectrics deposited at varying temperatures on (010) β-Ga2O3 and β-(AlxGa1−x)2O3 films with different Al compositions. The Al2O3/β-Ga2O3 MOSCAPs exhibited a strong dependence of electrical properties on Al2O3 deposition temperature. At 900 °C, reduced voltage hysteresis (∼0.3 V) with improved reverse breakdown voltage (74.5 V) was observed, corresponding to breakdown fields of 5.01 MV/cm in Al2O3 and 4.11 MV/cm in β-Ga2O3 under reverse bias. In contrast, 650 °C deposition temperature resulted in higher voltage hysteresis (∼3.44 V) and lower reverse breakdown voltage (38.8 V) with breakdown fields of 3.69 and 2.87 MV/cm in Al2O3 and β-Ga2O3, respectively, but exhibited impressive forward breakdown field, increasing from 5.62 MV/cm at 900 °C to 7.25 MV/cm at 650 °C. High-resolution scanning transmission electron microscopy (STEM) revealed improved crystallinity and sharper interfaces at 900 °C, contributing to enhanced reverse breakdown performance. For Al2O3/β-(AlxGa1−x)2O3 MOSCAPs, increasing Al composition (x) from 5.5% to 9.2% reduced net carrier concentration and improved reverse breakdown field contributions from 2.55 to 2.90 MV/cm in β-(AlxGa1−x)2O3 and 2.41 to 3.13 MV/cm in Al2O3. The electric field in Al2O3 dielectric under forward bias breakdown also improved from 5.0 to 5.4 MV/cm as Al composition increased from 5.5% to 9.2%. The STEM imaging confirmed the compositional homogeneity and excellent stoichiometry of both Al2O3 and β-(AlxGa1−x)2O3 layers. These findings demonstrate the robust electrical performance, high breakdown fields, and excellent structural quality of Al2O3/β-Ga2O3 and Al2O3/β-(AlxGa1−x)2O3 MOSCAPs, highlighting their potential for high-power electronic applications.