Odile Mourey

Odile Mourey

Auto-generated profile, based on publicly available information

Odile Mourey

SOITEC, Parc technologique des fontaines 2 , Bernin 38190

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2015 in Journal of Nuclear Materials
Verified
Journal Article
Open access
RBRégis Bisson
Régis Bisson
SMS. Markelj
S. Markelj
OMO. Mourey
O. Mourey
FGF. Ghiorghiu
F. Ghiorghiu
KAK. Achkasov
K. Achkasov
TAT. Angot
T. Angot
International audienceRetention of deuterium ion implanted in polycrystalline tungsten samples is studied in situ in an ultra-high vacuum apparatus equipped with a low-flux ion source and a high sensitivity thermo-desorption setup. Retention as a function of ion fluence was measured in the 10^17 -10^21 D+/m^2 range. By combining this new fluence range with the literature in situ experimental data, we evidence the existence of a retention = fluence^ 0.645±0.025 relationship which describes deuterium retention behavior on polycrystalline tungsten on 8 orders of magnitude of fluence. Evolution of deuterium retention as a function of the sample storage time in vacuum at room temperature was followed. A loss of 50% of the retained deuterium is observed when the storage time is increased from 2 h to 135 h. The role of the surface and of natural bulk defects on the deuterium retention/release in polycrystalline tungsten is discussed in light of the behavior of the single desorption peak obtained with Temperature Programmed Desorption

29 February 2016 in Applied Physics Letters
Verified
Journal Article
Closed access
GCG. Cunge
G. Cunge
MDMaxime Darnon
Maxime Darnon
JDJ. Dubois
J. Dubois
PBP. Bezard
P. Bezard
OMO. Mourey
O. Mourey
NSN. Sadeghi
N. Sadeghi
Several issues associated with plasma etching of high aspect ratio structures originate from the ions' bombardment of the sidewalls of the feature. The off normal angle incident ions are primarily due to their temperature at the sheath edge and possibly to charging effects. We have measured the ion velocity distribution function (IVDF) at the wafer surface in an industrial inductively coupled plasma reactor by using multigrid retarding field analyzers (RFA) in front of which we place 400 μm thick capillary plates with holes of 25, 50, and 100 μm diameters. The RFA then probes IVDF at the exit of the holes with Aspect Ratios (AR) of 16, 8, and 4, respectively. The results show that the ion flux dramatically drops with the increase in AR. By comparing the measured IVDF with an analytical model, we concluded that the ion temperature is 0.27 eV in our plasma conditions. The charging effects are also observed and are shown to significantly reduce the ion energy at the bottom of the feature but only with a “minor” effect on the ion flux and the shape of the IVDF.

8 September 2025 in Journal of Applied Physics
Verified
Journal Article
Open access
CBClaire Besancon
Claire Besancon
FMF. Martin
F. Martin
BGB. Ghyselen
B. Ghyselen
LLL. Largeau
L. Largeau
Frank FournelFrank Fournel
Frank Fournel
JDJ. Decobert
J. Decobert
Hetero-integration of InP-based compound semiconductors on CMOS-compatible silicon is desirable for low-cost large-scale applications. Recently, an approach consisting of integrating a thin InP buffer layer onto a silicon (InPoSi) substrate through direct bonding, followed by epitaxial regrowth on the bonded layer has been developed. It allows us to avoid the two major defects origins, antiphase domains and lattice mismatch, of the direct III–V/Si epitaxial approach. The remaining challenge comes from the difference of coefficients of thermal expansion between InP and Si, leading to a compressively strained InP seed layer at growth temperature. The latter was assessed from the curvature signal registered by in situ metrology during etching on the InP layer at typical growth temperature (640 °C) using a PH3/CBr4 mixture. The thermal strain effects on different heterostructures grown by MOVPE on InPoSi were studied by microscopy, Atomic Force Microscopy (AFM), x-ray diffraction (XRD), and photoluminescence measurements. In particular, regularly undulating surface topology was observed by microscopy, which could be associated with a broadening of the XRD peaks for heterostructures thicker than 1.5 μm. Strain-free InP-based structures were grown on InPoSi by adding 1% of Ga to the InP bulk layers to form an In0.99Ga0.01P alloy lattice-matched at growth temperature to the compressively strained InP bonded seed. The undulation for this strain-engineered film was hardly noticeable by AFM and was, therefore, successfully limited.

2 April 2026
Verified
Thesis
Closed access
OMOdile Mourey
Odile Mourey
La course à la miniaturisation des dispositifs oblige les industriels a développé sans cesse de nouvelles technologies de gravure afin de contourner les limites imposées par les procédés plasmas continus CW à haute densité. Parmi ces nouvelles technologies on trouve, les plasmas pulsés en impulsion courtes introduits depuis une dizaine d’année et le procédé de gravure cyclée développé très récemment par Applied Materials. Ces deux types de procédés de gravure présentent la caractéristique d’avoir un faible flux d’ions. Au premier abord, cette faible densité d’ions énergétiques permet la diminution des défauts induits par les ions. Cependant, un problème se pose lorsque le nombre d’ions impactant la surface devient trop faible (moins de 1 ions/site atomique/s). Ce travail de thèse se concentre donc ici sur l’étude de l’impact de la stochasticité du bombardement ionique sur l’état de la surface dans les deux procédés de gravure utilisés. Dans un premier temps, nous avons focalisé notre travail sur l’interaction entre les plasmas pulsés de chlore puis d’HBr et le silicium. A faible rapport de cycle, une très forte rugosité de surface a été observée sans lien avec un phénomène de micro-masquage. Des diagnostics plasma ont révélés que la présence d’un très faible flux d’ions énergétique couplé avec forte réactivité chimique engendre une forte augmentation du taux de gravure créant ainsi la rugosité de surface. Dans un second temps, l’étude du plasma capacitif d’hydrogène utilisé pour la modification du SiN durant le procédé de gravure cyclée a montré après retrait de la couche modifiée en plasma délocalisé, la présence d’une rugosité de surface au sommet des espaceurs nitrure qui n’est pas acceptable pour l’application du « simplified quadruple patterning ». Une étude paramétrique de l’état de surface a permis de mettre en évidence l’impact direct de la faible quantité d’ions H+ reçue par le matériau et la rugosité observée. La stochasticité du bombardement ionique implique donc une modification inhomogène du SiN qui est révélée lors de la phase de retrait et amplifiée au cours des cycles générant une rugosité de surface.Mots-clés : Microélectronique, procédés de gravure, plasma, stochasticité, ions.