1 February 2013 in Materials Science in Semiconductor Processing
1 May 2011 in Solar Energy Materials and Solar Cells
17 March 2020 in Journal of Lightwave Technology
Increasing demand of wireless devices contributes to radiofrequency (RF) congestion. Light Fidelity (LiFi) promises to be an interesting alternative by using the visible part of the electromagnetic spectrum instead of the RF part as nearly all existing wireless transmission systems do. A basic LiFi system is composed of one intensity-controlled light-emitting diode (LED) and one receiver device sensitive to very high-frequency (thus invisible to human sight) modulations of the luminous intensity. In most cases, the photoreceptor is a silicon photodiode of PIN (P-type intrinsic N-type) or APD (Avalanche photodiode) conception. Recently, a few studies suggest that photovoltaic (PV) modules could be used to implement outdoor LiFi transmissions, i.e., under direct sunlight exposure. In this paper, we propose to compare the behavior of a PV module and a commercial APD-based photodetector (without any optical lens or colored filter) for experimental LiFi transmissions on both indoor and outdoor conditions. The performance of the two solutions is quantified in terms of various frequency responses like attenuation, signal-to-noise ratio, or bit-error rate. The results show that, while the photodiode exhibits very good performance in indoor conditions, its frequency response is rapidly deteriorating when a sunlight exposure of more than $200 W/m^2$ is superimposed over the LiFi signal. We demonstrate that a PV module in $V_{oc}$ (open-circuit voltage) condition still operates a LiFi transmission under additional solar illumination.
15 July 2006 in Journal of Applied Physics
In this paper, the impact of iron contamination on the conversion efficiency of single-crystalline -type silicon solar cells is investigated by means of the combination of numerical simulations and experimental data, taking into account the more recent results about the properties of iron in single-crystalline silicon. Numerical simulations highlight the fill factor losses due to the injection-level dependence of the bulk lifetime, which attenuates the decrease of the open circuit voltage and thus that of the solar cell conversion efficiency with iron concentration. Gettering and hydrogenation effects are quantified by means of experimental results obtained from voluntarily contaminated solar cells and integrated in the simulations. The results show that iron appears to be a metallic impurity rather well tolerated in -type single-crystalline silicon solar cells, because its injection-level dependent bulk lifetime, like its abilities to be gettered and to be passivated by hydrogenation, limits its influence on the solar cell conversion efficiency.
15 October 2007 in Journal of Applied Physics
The influence of intentional iron bulk contamination on the performances of boron doped -type multicrystalline silicon solar cells was investigated. Solar cells were made from iron contaminated wafers, with an initial dissolved iron concentration 100 times higher than that of standard wafers. Nevertheless, the conversion efficiency of these cells was not impacted by this intentional contamination. We showed that this tolerance toward iron was due to the efficiency of the gettering and hydrogenation effects, complementary in this material. While phosphorus diffusion (extracting more than 99% of the iron from the bulk) is slightly limited in regions of high dislocation density, hydrogen diffuses through the whole thickness of the wafer and passivates defects and remaining impurities, with its diffusion being faster along extended defects
1 February 1998 in Physica Status Solidi (a)