Sandra Diez

Sandra Diez

Auto-generated profile, based on publicly available information

Sandra Diez

Applied Physics Program, University of Michigan 2 , Ann Arbor, Michigan 48109, USA

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 August 2021 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
PWPing Wang
Ping Wang
DWDing Wang
Ding Wang
BWBoyu Wang
Boyu Wang
SMSubhajit Mohanty
Subhajit Mohanty
SDSandra Diez
Sandra Diez
ZMZetian Mi
Zetian Mi
Molecular beam epitaxy of single-phase wurtzite N-polar ScxAl1−xN (x ∼ 0.11–0.38) has been demonstrated on sapphire substrates by locking its lattice-polarity to the underlying N-polar GaN buffer. Coherent growth of lattice-matched Sc0.18Al0.82N on GaN has been confirmed by x-ray diffraction reciprocal space mapping of the asymmetric (105) plane, whereas lattice-mismatched, fully relaxed Sc0.11Al0.89N and Sc0.30Al0.70N epilayers exhibit a crack-free surface. The on-axis N-polar crystallographic orientation is unambiguously confirmed by wet chemical etching. High electron mobility transistors using N-polar Sc0.18Al0.82N as a barrier have been grown on sapphire substrates, which present the existence of well confined two-dimensional electron gas. A Hall mobility of ∼564 cm2/V s is measured for a 15-nm-thick Sc0.18Al0.82N barrier sample with a sheet electron concentration of 4.1 × 1013 cm−2, and the corresponding sheet resistance is as low as 271 Ω/sq. The polarity-controlled epitaxy of ScxAl1−xN provides promising opportunities for applications in high-frequency and high-power electronic and ferroelectric devices.

27 July 2020 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SDSandra Diez
Sandra Diez
SMSubhajit Mohanty
Subhajit Mohanty
CKCagliyan Kurdak
Cagliyan Kurdak
EAElaheh Ahmadi
Elaheh Ahmadi
GaN-based high electron mobility transistors (HEMTs) have demonstrated high frequency power amplification with considerably larger output power densities than that available from amplifiers based on other material systems such as GaAs or InP. To further increase the operating frequency while maintaining the high output power in HEMTs, the gate-to-channel distance needs to be reduced significantly. This leads to a reduced two-dimensional electron gas (2DEG) density (ns) and mobility (μ) in Ga polar HEMT structures resulting in a larger sheet resistance. This work demonstrates that by proper design of the back-barrier in N-polar GaN-based scaled-channel HEMT structures, a high 2DEG density can be maintained while scaling the channel thickness. Scaled-channel GaN-based HEMT structures with an AlN/GaN (0.5 nm/1.5 nm) digital alloy as the back-barrier were grown on an on-axis N-polar GaN substrate via plasma-assisted molecular beam epitaxy. A record high electron mobility of 2050 cm2/vs was achieved on an N-polar HEMT structure with a 10 nm-thick channel, while maintaining 8 × 1012 cm−2 2DEG density. By modifying the barrier structure, we demonstrated a combination of 2DEG density and a mobility of 1.7 × 1013 cm−2 and 1420 cm2/V s, respectively, leading to a record low sheet resistance of ∼258 Ω/□ on 7 nm-thick channel N-polar HEMT structures.

16 December 2020 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
SMSubhajit Mohanty
Subhajit Mohanty
SDSandra Diez
Sandra Diez
ZJZhe (Ashley) Jian
Zhe (Ashley) Jian
EAElaheh Ahmadi
Elaheh Ahmadi
It has been previously shown that hole/donor traps at the (Al, Ga) N/GaN interface cause DC-RF dispersion and output conductance in N-polar GaN high electron mobility transistors (HEMTs). In this work, we systematically studied the impact of hole trap energy and density on two-dimensional electron gas (2DEG) density using Silvaco Atlas. Simulation results revealed that the exclusion of the hole traps in the model results in an underestimation of 2DEG density compared to experimentally obtained 2DEG density. By comparing simulations with the experimental results, a hole trap with a density of 3 × 1013 cm−2 at 280 meV above the valence band at the AlN/GaN negative polarization interface was estimated. Three different silicon doping schemes were then examined to suppress the effect of traps. Delta doping (15 nm) at the GaN buffer and barrier interface (doping Scheme-A) is effective in compensating traps present at that interface but insufficient to compensate traps near the GaN channel. Similarly, doping the back-barrier (doping scheme-B) is sufficient to neutralize traps in the middle of the back-barrier and close to the channel but inadequate to neutralize traps at the buffer–barrier interface. Series-C doping employs a combination of doping schemes A and B that effectively neutralizes traps present at all interfaces while simultaneously modulating the 2DEG charge density. An ultra-scaled 5-nm-thick GaN HEMT epitaxial structure was also designed by band engineering that can maintain high 2DEG density in the channel (2 × 013 cm−2) with less than 5% parasitic charge and trap ionization over a wide range of doping from 6 × 1018 cm−3 to 1 × 1019 cm−3.

29 September 2025 in Applied Physics Letters
Verified
Journal Article
Closed access
OOOguz Odabasi
Oguz Odabasi
IKIrfan Khan
Irfan Khan
SDSandra Diez
Sandra Diez
KKKamruzzaman Khan
Kamruzzaman Khan
TCTanmay Chavan
Tanmay Chavan
EAElaheh Ahmadi
Elaheh Ahmadi
In power amplifiers, achieving maximum drain efficiency requires deeper class-AB operation. Class-AB devices are biased near pinch-off, where the charge density is low. N-polar gallium nitride (GaN) high electron mobility transistors (HEMTs) have demonstrated exceptional performance, but they face a challenge of reduced electron mobility at low charge densities near pinch-off. This contrasts with conventional Ga-polar GaN HEMTs, where electron mobility increases as charge density decreases. In this work, we present an increase in electron mobility as charge density was reduced by applying a higher gate reverse bias in N-polar HEMT structures. The N-polar GaN HEMT structures presented here were grown on low-dislocation density on-axis N-polar GaN substrate using plasma-assisted molecular beam epitaxy (PAMBE). Epi-structures with different barrier materials, including InAlN and AlN/GaN digital alloy, were investigated. Electron mobility as a function of 2-dimensional electron gas (2DEG) density was extracted using a combination of the gated transfer length method and capacitance–voltage measurements. A record high mobility of 2000 and 6000 cm2/(V s) was achieved, at room temperature and 85 K, respectively, near pinch-off at a carrier density of 2.4 × 1012 cm−2. This study shows the potential of growth on on-axis substrates by PAMBE to improve efficiency in N-polar HEMTs.

1 December 2021 in APL Materials
Verified
Journal Article
Open access
PDF file
KKKamruzzaman Khan
Kamruzzaman Khan
SDS. Diez
S. Diez
KSKai Sun
Kai Sun
CWC. Wurm
C. Wurm
UMU. K. Mishra
U. K. Mishra
EAE. Ahmadi
E. Ahmadi
In this paper, we report on the observation of self-assembled InGaN/(In)GaN superlattice (SL) structure in a nominal “InGaN” film grown on N-polar GaN substrate. 350 nm thick InGaN films were grown at different temperatures ranging from 600 to 690 °C. Structural characterization was conducted via atomic force microscopy, scanning transmission electron microscopy, high-resolution x-ray diffraction, and XRD reciprocal space map. A SL structure was unexpectedly observed on all samples. However, the In content in each layer varied depending on growth temperature. By increasing the substrate temperature to 670 °C, a periodic structure composed of 3 nm In0.26Ga0.74N and 3 nm of GaN with a surface roughness of ∼0.7 nm was achieved. This work establishes a method for the growth of InGaN films with high structural quality on N-polar GaN and opens a new pathway for the design and fabrication of various electronic and optoelectronic devices with enhanced performance.