GaN-based high electron mobility transistors (HEMTs) have demonstrated high frequency power amplification with considerably larger output power densities than that available from amplifiers based on other material systems such as GaAs or InP. To further increase the operating frequency while maintaining the high output power in HEMTs, the gate-to-channel distance needs to be reduced significantly. This leads to a reduced two-dimensional electron gas (2DEG) density (ns) and mobility (μ) in Ga polar HEMT structures resulting in a larger sheet resistance. This work demonstrates that by proper design of the back-barrier in N-polar GaN-based scaled-channel HEMT structures, a high 2DEG density can be maintained while scaling the channel thickness. Scaled-channel GaN-based HEMT structures with an AlN/GaN (0.5 nm/1.5 nm) digital alloy as the back-barrier were grown on an on-axis N-polar GaN substrate via plasma-assisted molecular beam epitaxy. A record high electron mobility of 2050 cm2/vs was achieved on an N-polar HEMT structure with a 10 nm-thick channel, while maintaining 8 × 1012 cm−2 2DEG density. By modifying the barrier structure, we demonstrated a combination of 2DEG density and a mobility of 1.7 × 1013 cm−2 and 1420 cm2/V s, respectively, leading to a record low sheet resistance of ∼258 Ω/□ on 7 nm-thick channel N-polar HEMT structures.
We present a systematic study of low-frequency noise in Au nanoparticle chemosensors. All the sensors we have studied exhibit 1∕f-type noise at low frequencies. The magnitude of the 1∕f noise was smaller in devices with a larger device area, indicating that the 1∕f noise is caused by intrinsic processes. The noise amplitude was found to be strongly temperature dependent between 40–300K, with a local peak at around 100K, and weakly dependent below 40K. The noise data could not be fit by a single activated process indicating that multiple noise processes must be present in our sensors.
Use of electron-beam induced crosslinking to pattern films of monolayer-protected gold nanoparticles (MPNs) onto a chemiresistor (CR) sensor array is described. Each of the four CRs comprises a 100 µm2 set of interdigital electrodes (IDEs) with 100 nm widths and spaces, separated from adjacent devices by 4 µm. Films of four MPNs, each with a different thiolate monolayer, were successively patterned on the IDEs. Vapor exposures yield rapid, reversible changes in CR resistances and differential vapor sensitivities comparable to those reported for larger CRs with unpatterned MPN films. The array response patterns facilitate vapor discrimination. This is the smallest MPN-coated CR array yet reported. The advantages of using such an array as the detector in microfabricated gas chromatographic analyzers are considered.
We investigate the roles of disorder on low-temperature transport in crystals grown by both the Al flux and floating zone methods. We used the inverted resistance method with Corbino geometry to investigate whether low-temperature variations in the standard resistance plateau arise from a surface or a bulk channel in floating zone samples. The results show significant sample-dependent residual bulk conduction, in contrast to smaller amounts of residual bulk conduction previously observed in Al flux grown samples with Sm vacancies. We consider hopping in an activated impurity band as a possible source for the observed bulk conduction, but it is unlikely that the large residual bulk conduction seen in floating zone samples is solely due to Sm vacancies. We therefore propose that one-dimensional defects, or dislocations, contribute as well. Using chemical etching, we find evidence for dislocations in both flux and floating zone samples, with higher dislocation density in floating zone samples than in Al flux grown samples. In addition to the possibility of transport through one-dimensional dislocations, we also discuss our results in the context of recent theoretical models of .
We have realized by cleaved edge overgrowth a two‐dimensional electron gas system in a one‐dimensional lateral superlattice consisting of 100 periods of 120 Å GaAs/20 Å AlGaAs. These devices exhibit nonlinear I–V, including negative differential resistance, at high electric fields. We demonstrate, by monitoring the changes in the two‐dimensional electron density, that the nonlinear I–V is due to high field induced electron trapping.