Department of Renewable Energy, National Advanced School of Engineering of Maroua, University of Maroua, PO Box 58 Maroua, Cameroon. | Department of Energy, National Advanced School of Engineering of Douala, University of Douala, Douala, Cameroon
Auto-generated profile, based on publicly available information
Nsouandele Jean Luc
Department of Renewable Energy, National Advanced School of Engineering of Maroua, University of Maroua, PO Box 58 Maroua, Cameroon. | Department of Energy, National Advanced School of Engineering of Douala, University of Douala, Douala, Cameroon
Groundwater is essential for daily life in Cameroon, but pollution sources can harm its quality through infiltration and dispersal of contaminants in the ground. This study focuses on estimating groundwater quality near the Mbalmayo Thermal Power Plant using a predictive model combining genetic algorithms and neural networks. The genetic algorithms were used to optimize the objective function, while neural networks learned the data to predict concentration values. From January 2017 to December 2021, several moisture content values were experimentally determined using collected dried and weighed soil samples. The results showed that moisture content varied from 1 to 82%. During this study period, the model takes into account the water content of the soil, porosity and permeability which have the same effect on the concentration level of the fuel oil in the groundwater. The average concentration of fuel oil was below 50 mg/l, which is the World Health Organisation standard However, there is a risk of groundwater pollution by fuel oil in the event of heavy activity at the Mbalmayo thermal power plant in the 0-445 m range. For protection during this period, the results show that the installation of populations on a perimeter located beyond 445 m and the construction of a water purification station are recommended. The results are decision support tools for the authorities.
23 November 2023 in International Transactions on Electrical Energy Systems
In a grid-connected photovoltaic system, the quality of energy injected by the photovoltaic system into the grid is directly linked to the topology of the inverter used and to the efficiency of its control technique. This paper addresses this problem for a two-level grid-connected photovoltaic inverter operating under low irradiance conditions. The aim is to reduce the harmonic distortion on the electrical network and therefore improve its power quality. To achieve this goal, a control strategy was set up considering the nonlinearity of the dynamic system, and the high dimension of the system model. Thus, a nonlinear controller designed using the backstepping technique is proposed. The effectiveness of this control strategy was evaluated by simulation in MATLAB/Simulink. Results show that the proposed control technique significantly improves the power quality of the grid-connected photovoltaic system by minimizing the current harmonic distortion rates in low irradiance conditions. The current harmonic distortion rates obtained for solar irradiance of 1000W/m2, 750W/m2, 500W/m2, and 250W/m2 are 0.48, 0.78, 1.22, and 2.16, respectively. The power factor is 0.988, and the DC bus voltage is maintained at its reference voltage of 600V with a very low response time during the transient phases. A comparison of our simulation results with those found in the literature on other control techniques such as proportional-integral-derivative (PID) and synergetic controls shows the efficiency, superiority, and satisfactory performance of the proposed control scheme to minimize harmonic distortion under low irradiance conditions. The robustness and better dynamic performance of the proposed backstepping controller under varying irradiance conditions have also been shown.
The environmental impact of the cement industry is particularly significant in the release of suspended particulates and also substances such as nitrogen oxides and sulphur dioxide. This industry has very high energy requirements that can only be met by fossil fuels, hence its significant contribution to greenhouse gas (GHG) emissions. In Cameroon, for example, people living in the vicinity of cement works suffer from lung diseases (pneumonia, bronchitis, asthma and tuberculosis) due to atmospheric pollution from emissions from these industries. This study therefore assesses the quantities of GHGs emitted by the Figuil cement plant in northern Cameroon between 2016 and 2020, their distribution and mitigation in the atmosphere, and defines an environmental safety perimeter around the plant. The genetic algorithm-Gaussian (GA-Gaussian) coupling method was used for this assessment. The results obtained indicate that the Figuil cement plant emits an average of 526 kg of carbon dioxide (CO2), 971.41 kg of methane (CH4) and 309.41 kg of nitrous oxide (N2O) per month. GHGs gradually diminish with distance from their point of emission. The results show that GHGs no longer have a direct effect after 400 m from the cement plant, which represents the atmospheric safety zone around this cement production plant. Article Highlights’ Greenhouse gas emissions; Trends and variations in greenhouse gas emissions; Dispersion of atmospheric pollutants