Epoxy dielectrics with high through-plane thermal conductivity (λ) hold great promise for applications in the thermal management of advanced power electronics. Intensive attempts have been made to improve the λ of epoxy by filling with boron nitride nanosheets (BNNSs). However, it remains a great challenge to achieve a satisfactory increased λ by a small amount of BNNS loading. Herein, we reported a new strategy to prepare epoxy dielectrics with internal three-dimensional phonon transport channels by vacuum freeze-drying and vacuum impregnation. Aramid nanofibers (ANFs) and BNNSs were used for the collaborative construction of a vertical interconnected thermal framework. The resultant ANF-BNNS/epoxy achieved a high through-plane λ of 0.87 W m−1 K−1 at only 1.43 vol. % BNNS, which is ∼17.1% higher than that of the BNNS/epoxy counterpart with even 18.34 vol. % randomly distributed BNNS. The increasing efficiency of λ of epoxy by ANF-BNNS is tenfold more than that of the conventional blending methods. In addition, the ANF-BNNS/epoxy composite also exhibits a low dielectric constant and low dielectric loss. The findings of this study offer an inspired venue to develop high-performance thermally conductive epoxy dielectrics with a minimal BNNS loading.
Deep level defects in annealed InP have been studied by using photoluminescence spectroscopy (PL), thermally stimulated current (TSC), deep level transient spectroscopy (DLTS), and positron annihilation lifetime (PAL). A noticeable broad PL peak centered at has been observed in the InP sample annealed in iron phosphide ambient. Both the PL emission and a defect at correlate with a divacancy detected in the annealed InP sample. The results make a divacancy defect and related property identified in the annealed InP.
Accurately and flexibly tracking the operating point of photovoltaic (PV) system under partial shading condition (PSC) is challenging due to the multipeak feature of power-voltage (P-V) curve, especially with the aim of flexible power control (FPC). This article proposes a global FPC (GFPC) method based on a direct multipeak curve-fitting of PV system under PSC. First, an optimized search skip and judgment–global maximum power point tracking (GMPPT) method is applied to accurately and quickly track the maximum power point. During the GMPPT process, the key points on the P-V curve, e.g., local MPPs and stationary points, are recorded, which are then applied for direct fitting of the multipeak P-V curve. Subsequently, a pseudomonotonic P-V curve is developed as a reference for locating the flexible power point according to the GFPC demands. The directly obtained pseudomonoatomic P-V curve enables fast and flexible power adjustments without redundant perturbation and tracking processes. The results of simulations on MATLAB/Simulink and experiments on StarSim platform demonstrate that the proposed GFPC method can quickly and accurately adjust the PV power adapting to flexible control demands and grid support requirements. Then, the flexibility and adaptability of PV systems as well as the stability of power grid are enhanced.