The composite TiO2/Mo-TiO2 were prepared by a modified sol-gel method. The prepared catalysts were characterized by X-ray diffraction, BET analysis, SEM, X-ray photoelectron spectroscopy, and UV–vis diffused reflectance spectroscopy techniques. The structural characterization results demonstrated that Mo was successfully doped into the TiO2 lattice and caused slight changes in the physiochemical properties. The UV–vis DRS showed a red shift of the adsorption edge to the visible region. The photocatalytic decomposition efficiencies of the catalysts were examined with toluene as a typical VOC in a continuous flow reactor. The photocatalytic activity of the n-n heterogeneous TiO2/Mo-TiO2 was greater than that of pure TiO2 and Mo-TiO2, and the catalyst containing a Mo/Ti mole ratio of 2.5% exhibited optimum photocatalytic properties. In general, a relative humidity of 35%, a higher oxygen content, a lower initial toluene concentration, and a higher UV intensity were beneficial for toluene decomposition.
The anti-solvent recrystallization process for the preparation of salt microparticles is introduced. The micron size of salt particles was confirmed by scanning electron microscopy. The preparation conditions such as the antisolvent types, dripping acceleration, stirring time, the volume ratio of antisolvent and solvent, and adding sequence of solvent were optimized. The experimental results indicated that these preparation conditions were as follows: The saturated salt solution was added into absolute alcohol at a dripping acceleration of 10 mL · min−1, a stirring time duration of 30 min, and an antisolvent and solvent volume ratio of 4 : 1. Salt microparticles with an average diameter of about 6.3 μm, uniform size distribution and better crystallization were obtained under the above optimization conditions.