Zhe Zhang

Zhe Zhang

Auto-generated profile, based on publicly available information

Zhe Zhang

Key Laboratory of Microelectronic Devices and Circuits (MOE), Institute of Microelectronics, Peking University, Beijing 100871, China

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 January 2018 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
ZZZhe Zhang
Zhe Zhang
XJXiaobo Jiang
Xiaobo Jiang
RWRunsheng Wang
Runsheng Wang
SGShaofeng Guo
Shaofeng Guo
YWYangyuan Wang
Yangyuan Wang
RHRu Huang
Ru Huang
A parameter extraction methodology of statistical process variations in FinFET is presented in this paper. First, the main impacts of various variation sources are decomposed, with detailed discussion on the correlation between threshold voltage and subthreshold swing. Second, following the Fin-edge roughness (FER) and gate-edge roughness (GER) compact models, the physical parameters, autocorrelation length and amplitude of root mean square of FER and GER, are extracted based on our proposed extraction procedure. Given a set of $I$-$V$ (whether from TCAD or measured silicon data), this method can simply extract the process variation parameters from several experimental sets, such as experiments under different device geometries and/or bias conditions. With the extracted parameters integrated into compact models, the figure of merits of simulation program with integrated circuit emphasis results are well consistent with experimental measurements. The proposed methodology is not only helpful for model-based design-technology co-optimization, but also helpful for variation-aware circuit design.

29 May 2020 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
ZYZhuoqing Yu
Zhuoqing Yu
ZZZhe Zhang
Zhe Zhang
ZSZixuan Sun
Zixuan Sun
RWRunsheng Wang
Runsheng Wang
RHRu Huang
Ru Huang
In this brief, typical locations of the interface and oxide traps generated by the hot carrier degradation (HCD) in FinFETs are studied with experiments and ``atomistic'' TCAD simulations under the worst case stress conditions. The typical round-Fin locations of different types of traps are analyzed by comparing the experimentally extracted results with the calibrated TCAD simulations. Then, the traps' different impacts on HCD variations in both forward and reverse bias modes are employed to disclose the typical lateral locations of different traps. The results suggest that for both n- and p-type of FinFETs under the worst case stress conditions, the interface traps and oxide traps (type 1) are mainly distributed in the midchannel region closer to the source side on the Fin side, whereas oxide traps (type 2) are mainly distributed in the midchannel region closer to the drain side on the Fin top. Therefore, the two types of oxide traps originate in the different generation locations but may share the same atomistic structures in the same device. The results are helpful to the physical understandings of HCD in the FinFET technology.

1 October 2023
Verified
Conference Paper
Closed access
KXKaiqiang Xiong
Kaiqiang Xiong
RPRui Peng
Rui Peng
ZZZhe Zhang
Zhe Zhang
TFTianxing Feng
Tianxing Feng
JJJianbo Jiao
Jianbo Jiao
RWRonggang Wang
Ronggang Wang
Unsupervised Multi-View Stereo (MVS) methods have achieved promising progress recently. However, previous methods primarily depend on the photometric consistency assumption, which may suffer from two limitations: indistinguishable regions and view-dependent effects, e.g., low-textured areas and reflections. To address these issues, in this paper, we propose a new dual-level contrastive learning approach, named CL-MVSNet. Specifically, our model integrates two contrastive branches into an unsupervised MVS framework to construct additional supervisory signals. On the one hand, we present an image-level contrastive branch to guide the model to acquire more context awareness, thus leading to more complete depth estimation in indistinguishable regions. On the other hand, we exploit a scene-level contrastive branch to boost the representation ability, improving robustness to view-dependent effects. Moreover, to recover more accurate 3D geometry, we introduce an ℒ0.5 photometric consistency loss, which encourages the model to focus more on accurate points while mitigating the gradient penalty of undesirable ones. Extensive experiments on DTU and Tanks&Temples benchmarks demonstrate that our approach achieves state-of-the-art performance among all end-to-end unsupervised MVS frameworks and outperforms its supervised counterpart by a considerable margin without fine-tuning.

16 July 2021 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
ZZZuodong Zhang
Zuodong Zhang
RWRunsheng Wang
Runsheng Wang
XSXuguang Shen
Xuguang Shen
DWDehuang Wu
Dehuang Wu
JZJiayang Zhang
Jiayang Zhang
RHRu Huang
Ru Huang
Due to severer transistor aging at nanoscale, circuit design margin becomes extremely tight for advanced technology nodes. Thus, reliability-aware circuit design is urgently needed. In this article, a new framework to perform aging-aware static timing analysis (STA) is presented for reliability analysis. The key parts of aging-aware STA flows are workload analysis and aged delay/transition calculation. For the workload analysis, a new analytical stress probability (SP) calculation model is proposed, which considers the floating effect and signal correlations. For aged delay/transition calculation, a new aging-aware model is developed, which is accessible to large industrial libraries. The results show that the proposed model achieves high accuracy in the degradation estimation and aged-path-delay calculation. Due to its high accuracy and scalability, the proposed framework is a promising solution that is compatible with commercial Electronic Design Automation (EDA) tools.

12 January 2021 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
XLXianglong Li
Xianglong Li
XYXiaoqiao Yang
Xiaoqiao Yang
ZZZhe Zhang
Zhe Zhang
TWTeng Wang
Teng Wang
YSYabin Sun
Yabin Sun
Jun XuJun Xu
Jun Xu
In this article, the impact of intrinsic process fluctuations on reconfigurable field-effect transistor (RFET) is investigated for the first time. Three kinds of process fluctuation sources, including line edge roughness (LER), gate edge roughness (GER), and work-function variation (WFV), are performed in RFET using MATLAB and 3-D TCAD. The variation of ON-state current ${I}_{ \mathrm{\scriptscriptstyle ON}}$ due to LER presents a weak correlation with that of OFF-state current ${I}_{ \mathrm{\scriptscriptstyle OFF}}$ . Performance variation caused by GER is mainly attributed to the control GER. WFV in control gate and source dominates the variations of ON-state characteristics. The total overall performance fluctuations are primarily attributed to WFV. In the sight of ${I}_{ \mathrm{\scriptscriptstyle ON}}$ , WFV contributed up to 84.7% and 82.8% of the total fluctuations for n- and p-type, respectively.

8 May 2020 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
ZZZuodong Zhang
Zuodong Zhang
RWRunsheng Wang
Runsheng Wang
ZZZhe Zhang
Zhe Zhang
YZYawen Zhang
Yawen Zhang
SGShaofeng Guo
Shaofeng Guo
RHRu Huang
Ru Huang
Reliability-enhanced circuit design is increasingly demanded due to severer transistor aging and variations at nanoscale. In this brief, new insights of inherently enhancing reliability are presented, based on the emerging computing paradigm of stochastic computing (SC). A new cross-layer reliability simulation flow supporting statistical static timing analysis (SSTA) is proposed, with a new long-term compact transistor aging model validated by 16/14nm FinFET experimental data. Then, the reliability of SC circuits in practical applications is investigated and compared with that of conventional binary circuits, for the first time. The results indicate that, the performance of SC circuits is intrinsically resistant to aging and variations ascribed to the circuit topology and the probability encoding. It suggests that, SC can provide more relaxed circuit design margins, offering promises to the application of emerging nanodevices in the future.