This paper presents in-stope measurements of total stress and pore-water pressure at strategic locations within three underground stopes at the Raleigh mine site (Western Australia) that were filled with cemented paste backfill (CPB). The three stopes were very similar in shape. Key differences among the stopes were the filling and resting schedules, the barricade drainage systems used, and the cement content of the CPB. Data from the stopes are compared to determine which controllable factors most significantly influence barricade pressures during and after filling. The most significant factor was the scheduling of rest periods between filling, with even very short pauses in filling dramatically reducing the rate of increase of pore-water pressure and total stress with increasing height of fill.
Cemented paste backfill (CPB) has been observed to achieve greater cemented strength when cured in situ compared with equivalent mixes cured and tested in a laboratory environment. This is in part due to the development of effective stress and generation of elevated temperatures by exothermic cement hydration reactions occurring during curing in a typical underground stope environment. This differs from curing in typical laboratory environments, where little or no effective stresses are generated and curing occurs under constant-temperature conditions. This paper outlines the development, calibration, and testing of a temperature-controlled hydration cell that provides closer representation of in situ conditions by controlling the rate and final amount of specimen temperature increase, in addition to curing under effective stress. The temperature-controlled hydration cell was used to examine the effect of curing under combined effective stress and temperature conditions on the development of small-strain stiffness over a 7 day curing period and the unconfined compressive strength at the end of this period. Curing with both elevated temperature and effective stress was found to significantly increase the mechanical properties of CPB compared with curing at elevated effective stress or ambient temperatures alone.
1 December 2005 in Journal of Geotechnical and Geoenvironmental Engineering
Solutions are presented for stiffness coefficients to represent the elastic behavior of a caisson foundation embedded in soil. The solutions use a novel numerical technique, the scaled boundary finite element method, combined with shell elements to represent the foundation itself. The stiffness coefficients take into account the possibility of nonhomogeneity in the soil (stiffness varying with depth), the geometry of the foundation, and the contribution to the stiffness of the skirt of the caisson foundation. Tabulated values allow a simple curve fit to the stiffness values to be employed for particular cases. The accuracy of the method is tested against previous solutions for particular cases. Example calculations are given to illustrate the method.
A constant-volume direct simple shear apparatus was used to investigate the effects of confining stress, initial static shear stress and void ratio on the liquefaction resistance of fine-grained tailings. The cyclic resistance ratio (also expressed as the overburden stress correction factor) was found to decrease with increasing confining stresses in the range 100–400 kPa and to gradually increase from 400 kPa onwards, when samples were tested at the same initial void ratio. The presence of an initial static shear stress decreased the liquefaction resistance. A key outcome of the work was to reveal the critical importance of density on liquefaction susceptibility of compressible tailings. Thus, a combined correction factor to account for overburden stress and density on cyclic resistance was proposed.