The dynamic characteristics of a subnanosecond pulsed electron beam formation in the accelerating gap of a gas-filled or evacuated diode have been studied at a time resolution ∼10−11 s. In the air-filled gap, the electron beam pulse with a current amplitude of several amperes is formed up to about one hundred picoseconds earlier than the analogous pulse under vacuum conditions, and the measured pulse duration (∼10−10 s) is close to the electron flight time across a diode gap in the continuous acceleration regime. It is shown that a nanosecond prepulse plays an important role by initiating the emission of electrons that are subsequently accelerated by the high-voltage pulse with a subnanosecond front.
1 June 1996 in IEEE Transactions on Plasma Science
A study has been performed on the emissive characteristics of a cold graphite cathode in a magnetically insulated coaxial diode under the action of nanosecond accelerating pulses at a pulse repetition frequency (PRF) of up to 3.5 kHz. Emission was observed to degrade at PRF < 1 kHz and recover at PRF ~3.5 kHz. Estimates of the temperature conditions in the region of an explosive electron emission (EEE) center have shown that the pulse interval t~1 ms suffices for this region to cool down to 300 K. The cooling occurs predominantly by heat conduction. For t~0.3 ms, the residual heat is substantial. It has been proposed that there exists a frequency limit for the cathode microrelief polishing effect. The results of an experiment on the study of the mechanism of cathode emission recovery with increasing PRF are presented. Micrographs of the cathode taken after aging, photographs of the cathode in operation, and analyses of the fractional composition of the material removed from the cathode suggest that heating of some regions of the cathode emitting edge to the melting point of graphite plays an important role in the recovery of emission. This counts in favor of the hypothesized dominant contribution of thermoelectronic emission to the initiation of EEE due to the residual heat remaining in regions that have not cooled off during the pulse interval
15 August 2005 in IEEE Transactions on Plasma Science
Results of tests of a fast-repetitive nanosecond modulator with a peak output power of 3 GW are presented. It comprises of a type S-5N charging driver, a power compressor based on a pulsed forming line, and a gas spark gap. The modulator has been designed for the formation of high-current electron beams and high-power microwave generation in a pulsed-repetitive regime. Excitation of 10-GHz microwave pulses /spl sim/1 ns long in a relativistic backward-wave oscillator with an elongated periodic slow-wave system has been studied. Optimization of the regime of interaction between electromagnetic fields and particles provided an average power of microwave radiation in the burst-repetitive mode (1 s; /spl sim/700 Hz) of up to 2.5 kW at a focusing magnetic field (/spl sim/0.6 T) below the cyclotron resonance region. The peak output power of the oscillator exceeded 2 GW.
The electron beam transported in a two-section drift tube of a SINUS-7 setup has been studied. A high-density electron beam in the “squeezed” state has been obtained with a relativistic factor γb below that corresponding to the limiting current (γ > Γ1/3).
We have experimentally studied the possibility of increasing the working life of explosive-emission cathodes operating at high repetition frequencies (several kilohertz) of nanosecond accelerating voltage pulses. Micrographs of the cathode surface upon training, photographs of the operating cathode, and analyses of the material carried away from the cathode showed that a substantial role in the cathode degradation is played by heating of some regions of the emissive edge up to a temperature of graphite melting.