The dynamic characteristics of a subnanosecond pulsed electron beam formation in the accelerating gap of a gas-filled or evacuated diode have been studied at a time resolution ∼10−11 s. In the air-filled gap, the electron beam pulse with a current amplitude of several amperes is formed up to about one hundred picoseconds earlier than the analogous pulse under vacuum conditions, and the measured pulse duration (∼10−10 s) is close to the electron flight time across a diode gap in the continuous acceleration regime. It is shown that a nanosecond prepulse plays an important role by initiating the emission of electrons that are subsequently accelerated by the high-voltage pulse with a subnanosecond front.
Alternative factors that account for a limitation of the period of injection of picosecond runaway electron bunches in air-filled diode with inhomogeneous electric field are analyzed. Experimental data on the characteristics of such electron beams have been obtained under the conditions with variable emissive properties of the cathode, time of the voltage prepulse action, and electric field strength in the region of electron injection. Based on these data, a hypothesis is formulated and justified that the mechanism of limitation related to a transition from the field electron emission to the explosion of microinhomogeneities is less probable than the mechanism of current limitation by a screening plasma cloud formed over the point electron emitters.
16 October 2006 in IEEE Transactions on Plasma Science
A study has been performed on the emissive characteristics of a cold graphite cathode in a magnetically insulated coaxial diode under the action of nanosecond accelerating pulses at a pulse repetition frequency (PRF) of up to 3.5 kHz. Emission was observed to degrade at PRF < 1 kHz and recover at PRF ~3.5 kHz. Estimates of the temperature conditions in the region of an explosive electron emission (EEE) center have shown that the pulse interval t~1 ms suffices for this region to cool down to 300 K. The cooling occurs predominantly by heat conduction. For t~0.3 ms, the residual heat is substantial. It has been proposed that there exists a frequency limit for the cathode microrelief polishing effect. The results of an experiment on the study of the mechanism of cathode emission recovery with increasing PRF are presented. Micrographs of the cathode taken after aging, photographs of the cathode in operation, and analyses of the fractional composition of the material removed from the cathode suggest that heating of some regions of the cathode emitting edge to the melting point of graphite plays an important role in the recovery of emission. This counts in favor of the hypothesized dominant contribution of thermoelectronic emission to the initiation of EEE due to the residual heat remaining in regions that have not cooled off during the pulse interval
This letter reports new results on the formation of a paraxial flow of runaway electrons emitted in an elongated air gap near the tip of a conical steel cathode. In the axial magnetic field > 4 T, the peak current density of ≈ 0.6 kA/cm 2 has been achieved in the bunch core with a 0.7 mm diameter. Similarly to the vacuum case, dependence of the bunch parameters on the magnetic field was obtained and interpreted. Analysis of recorded current waveforms and oscilloscope transient response shows that the original current pulse rise time and width did not exceed 5 and 10 ps, respectively. Using the time-of-flight method, we have estimated the particle kinetic energy (≈200 keV) at the peak of the distribution function.
The stability of operation of parallel explosive-emission cathodes driven by a split high-voltage pulse with a subnanosecond leading front has been studied. It is established that, upon the training of graphite cathodes in vacuum with up to ∼104 pulses, the current pulse fronts of injected high-current electron beams exhibit a mutual temporal dispersion not exceeding ten picoseconds. The dynamics of this parameter during the training stage, the variation of the absolute spread, and the growth of a relative delay of the moments of beam injection have been investigated.
10 June 2008 in IEEE Transactions on Plasma Science
This paper presents the results of the theoretical and experimental studies of an efficient and stably operating microwave source with a nanosecond high-current electron beam in an extended backward-wave-oscillator-type slow-wave structure. The possibilities for stabilization of the RF field phase and for minimization of the pulse-to-pulse peak power spread have been demonstrated. Possible mechanisms of the stabilization of peak microwave power are considered, with emphasis placed on the mode in which a part of the particles are reflected in an intense RF field.