22 March 2010 in IEEE Transactions on Industrial Electronics
Employing fuel cell (FC) as main source requires increasing and regulating its output voltage. In this paper, nonisolated dc-dc converter with high voltage ratio is proposed to interface between the FC and high-voltage dc bus. To take into account the low-voltage-high-density characteristics of power sources, a cascaded structure composed of two subconverters in cascade has been chosen and allows obtaining high voltage ratio. The choice of each subconverter is based on source requirements and its performances. Consequently, in this paper, a converter consisting of two-interleaved boost converter is chosen as first subconverter and a three-level boost converter is chosen as second subconverter. Control of the whole system is realized by energy trajectory planning based on flatness properties of the system. The design of trajectories is explained and allows respecting the fuel-cell constraints as main power source. To ensure correct design of the energy trajectories, a noninteger power-law function is used to model the static characteristic of the FC. This law allows investigating the effect of humidity and temperature on the dynamics of the proposed system. The control of both current and voltage balance across the output serial capacitors of the three-level boost converter is ensured by nonlinear controllers based on a new nonlinear model.
3 April 2013 in IEEE Transactions on Power Electronics
In this paper, a new current sharing technique on a general case of N paralleled DC-DC boost converters is presented. The proposed optimization is based on the knowledge of individual boost parameters. Every loss through the structure are modeled by equivalent resistors. Using an accurate online estimation of those resistors, the losses through each individual converter can be determined. Then, a new current sharing scheme is defined aiming to maximize the global efficiency of the overall structure. To verify the proposed method, simulations and experiments have been realized on a three-parallel boost converters structure.
5 April 2011 in IEEE Transactions on Power Electronics
This paper presents a new method for filtering the HF current ripple generated by current-fed dc/dc converters. This method is based on the use of an active filter connected in parallel with the source, without any passive filter between the source and the power converter. The design of this new active filter and its associated controllers are fully explained in the paper. Experimental results validate the proposed filtering method. The structure of the proposed active filter is patented at the World Intellectual Property Organization under the number WO/2008/132318.