13 September 2022 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
8 November 2023 in Journal of Vacuum Science & Technology B
Non-evaporable getter (NEG) films are widely used in high vacuum technologies and have played a critical role in applications requiring ultrahigh vacuum conditions, such as accelerator vacuum systems. The passivation layers on the film surface due to air exposure generally require thermal vacuum activation. This research aims to elucidate the key factor in the activation of TiZrV NEG films from the perspective of atomic-scale microstructures. The characteristics of film element distributions, morphologies, and crystalline states before and after activation were investigated by energy dispersive spectroscopy, scanning electron microscopy, and grazing incidence x-ray diffraction. In situ x-ray photoelectron spectroscopy was used to detect compositional variations in the film surface layer at different activation temperatures. According to the analysis, from an atomic-scale perspective, the easily activated structures would degrade in activation performance when surrounded by structures that are difficult to activate. During activation, the activated structures tend to act as channels for foreign atoms until the surrounding structures are fully activated. Hydroxyl and carbonyl groups are generally easier to activate than hydrocarbons and surface carbides, but even groups of the same type vary greatly in activation difficulty due to the differences in atomic-scale microstructures on the film surface. These findings provide valuable insight into the activation of NEG films and may be beneficial in the design of novel NEG films with excellent activation performance.
26 January 2025 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
26 March 2025 in Journal of Vacuum Science & Technology B
The China Spallation Neutron Source (CSNS) is an accelerator-based multidisciplinary user facility located in Dongguan, Guangdong, China. It was launched in 2011 and started delivering neutron beams to users in March 2018. The CSNS complex consists of an H− linear accelerator, a rapid cycling synchrotron that accelerates the beam to 1.6 GeV, a solid tungsten target station, and various instruments for spallation neutron applications. This paper focuses on the vacuum system from the H− ion source to the Drift Tube Linac, aiming to review the operations of the CSNS Linac vacuum system over the past nine years. Specifically, it discusses the main challenges encountered and the actions taken to overcome them. Additionally, it evaluates the preliminary engineering design of the CSNS II Linac vacuum system.
11 January 2022 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
1 September 2024 in Journal of Instrumentation
The fourth-generation light source or future particle accelerators have compact vacuum systems, resulting in a small flow conductance of the beam chamber. The development of NEG (Non-Evaporable Getters) films technology with distributed pumping is a good solution. This technology can obtain a pressure distribution with a small pressure gradient and an ultra-high vacuum of 10-8 Pa inside the vacuum chambers. In the magnetron sputtering process for NEG coating, the inhomogeneity of the magnetic field at the edge of the solenoid is a key parameter for affecting the stability of the magnetron sputtering discharge process. The influence mechanism of the edge magnetic field on the plasma discharge process and discharge uniformity was studied to optimize the coating parameters, which is very important. The Particle-In-Cell/Monte Carlo Collision (PIC/MCC) method was employed to simulate plasma discharge in a narrow vacuum chamber under various edge magnetic field conditions. The potential distribution, charged particle density distribution, and particle density distribution on the target were acquired for four sets of discharge parameters, followed by data processing and analysis. The electric field distribution during the discharge process is closely linked to the non-uniformity of the magnetic field at the solenoid's edge. The smaller Br (the radial component of the magnetic field) component of the magnetic field, the more uniform distribution of Ar+ on the target surface, and the smaller the difference along the length of the vacuum chamber. A smaller radial component (Br) of the magnetic field results in a more uniform distribution of Ar+ on the target surface and reduces variations in film thickness along the length of the vacuum chamber. This is attributed to the small distance between the inner wall of the vacuum chamber and the cathode target. The change in the edge magnetic field will result in the rapid migration of electrons to the inner wall of the vacuum chamber and insufficient collision with the discharge gas, making it challenging to sustain the discharge process. Moreover, fluctuations in the edge magnetic field of the solenoid induce gradient drift and curvature drift in charged particles, resulting in rapid electron loss and alterations in the density and potential distribution of charged particles at the ends of the vacuum chamber, ultimately leading to discharge instability. The research results show the importance of the edge magnetic field effect on the magnetron sputtering coating of the slender vacuum chambers, which provides an important reference for the segmented coating process of similar vacuum chambers in future accelerators.