25 June 2018 in Applied Physics Letters
Epitaxial p-i-n structures grown on native GaN substrates have been fabricated and used to extract the impact ionization coefficients in GaN. The photomultiplication method has been used to experimentally determine the impact ionization coefficients; avalanche dominated breakdown is confirmed by variable-temperature breakdown measurements. To facilitate photomultiplication measurements of both electrons and holes, the structures include a thin pseudomorphic layer on the cathode side of the drift layer. Illumination with 193 nm and 390 nm UV light has been performed on diodes with different intrinsic layer thicknesses. From the measured multiplication characteristics, the impact ionization coefficients of electrons (α) and holes (β) were determined for GaN over the electric field range from 2 MV/cm to 3.7 MV/cm. The results show that for transport along the c-axis, holes dominate the impact ionization process at lower electric field strengths; the impact ionization coefficient of electrons becomes comparable to that of holes ( ) for electric field strengths above 3.3 MV/cm.
9 July 2018 in Applied Physics Letters
An approach to realizing high-voltage, high-current vertical GaN-on-GaN power diodes is reported. We show that by combining a partially compensated ion-implanted edge termination (ET) with sputtered SiNx passivation and optimized ohmic contacts, devices approaching the fundamental material limits of GaN can be achieved. Devices with breakdown voltages (Vbr) of 1.68 kV and differential specific on resistances (Ron) of 0.15 mΩ cm2, corresponding to a Baliga figure of merit of 18.8 GW/cm2, are demonstrated experimentally. The ion-implantation-based ET has been analyzed through numerical simulation and validated by experiment. The use of a partially compensated ET layer, with approximately 40 nm of the p-type anode layer remaining uncompensated by the implant, is found to be optimal for maximizing Vbr. The implant-based ET enhances the breakdown voltage without compromising the forward characteristics. Devices exhibit near-ideal scaling with area, enabling currents as high as 12 A for a 1 mm diameter device.
8 February 2021 in IEEE Transactions on Electron Devices
The temperature dependence of the electron and hole impact ionization coefficients in GaN has been investigated experimentally. Two types of p-i-n diodes grown on bulk GaN substrates have been fabricated and characterized, and the impact ionization coefficients for both electrons and holes have been extracted using the photomultiplication method. Both the electron and hole impact ionization coefficients decrease as the temperature increases. The Okuto-Crowell model was used to describe the temperature dependence of the electron and hole impact ionization coefficients. Based on the measured impact ionization coefficients, the temperature dependence of the breakdown voltage of GaN non-punch through p-n diodes can be predicted; good agreement with experimentally reported results is obtained.
14 September 2018 in IEEE Microwave and Wireless Components Letters
Low-loss coplanar waveguides (CPWs) on AlGaN/GaN HEMT heterostructures grown on high-resistivity Si substrates (GaN-on-Si) are demonstrated. Performance has been evaluated from 0.1 to 20 GHz, and loss as low as 0.27 dB/mm at 20 GHz is achieved. The performance of CPWs fabricated with ion implant- and mesa etching-based processes are compared, and finite element simulations are used to analyze the CPW loss mechanisms. In this frequency range, the dielectric loss associated with the GaN-on-Si substrate is below 0.065 dB/mm, compared to approximately 0.01 dB/mm for reference GaN-on-SiC CPW lines. The extra loss in the GaN-on-Si CPWs is due to a parasitic conductive layer with a sheet resistance of 2 × 10 4 Ω/□. The low loss obtained, combined with the economic and integration advantages of GaN-on-Si substrates, makes them promising for GaN monolithic microwave integrated circuits.
10 September 2018 in IEEE Electron Device Letters
High-performance vertical GaN-based p-n junction diodes fabricated using bandgap selective photoelectrochemical etching-based epitaxial liftoff (ELO) from bulk GaN substrates are demonstrated. The epitaxial GaN layers and pseudomorphic InGaN release layer were grown by MOCVD on bulk GaN substrates. A comparison study was performed between devices after liftoff processing (after transfer to a Cu substrate) and nominally identical control devices on GaN substrates without the buried release layer or ELO-related processing. ELO and bonded devices exhibit nearly identical electrical performance and improved thermal performance, compared with the control devices on full-thickness GaN substrates. The breakdown voltage, ideality factor, and forward turn-ON performance were found to be nearly identical, indicating that the transfer process does not degrade the quality of the p-n junctions. The devices exhibit turn-ON voltages of 3.1 V at a current density of 100 A/cm 2 , with a specific ON-resistance ( ${R} _{ \mathrm{\scriptscriptstyle ON}}$ ) of 0.2–0.5 $\text{m}\Omega \cdot \text {cm}^{{2}}$ at 5 V and a breakdown voltage ( ${V} _{\text {br}}$ ) of 1.3 kV. Both optical and electrical characterization techniques show that the thermal resistance of ELO devices bonded to a Cu carrier is approximately 30% lower than that for control devices on GaN substrates.
22 April 2024 in Applied Physics Letters
We report the direct observation of radio-frequency negative differential resistance, via on-wafer S-parameter measurements, in GaN-based impact ionization avalanche transit time (IMPATT) diodes. Clear signatures of reflection gain are observed from 18.7 to 30.6 GHz. These observations have been made possible by suppressing the reverse leakage current (and thereby parasitic shunt conductance) by optimization of the fabrication process, in conjunction with the use of pulsed measurements to suppress device self-heating. Consistent with avalanche-dominated behavior, the measured DC reverse bias current–voltage measurements show a positive temperature coefficient of breakdown. For the high-frequency on-wafer characterization, pulsed-bias S-parameter measurements with low (0.0067%) duty cycle were used to mitigate thermal effects. The measured avalanche frequency aligns closely with theoretical predictions based on Gilden and Hines' small signal model [Gilden and Hines, IEEE Trans. Electron Devices ED-13(1), 169–175 (1966)], measured impact ionization coefficients [Cao et al., Appl. Phys. Lett. 112(26), 262103 (2018)], and experimental saturation velocity measurements [Bajaj et al., Appl. Phys. Lett. 107(15), 153504 (2015)]; this excellent agreement confirms IMPATT operation and provides insights needed to further optimize device performance.