Employment DC-DC switching power converters in many different areas become is very important. In this paper, three different models of the photovoltaic solar module were proposed in order to designing, implementation, and simulated them in MATLAB/Simulink with the boost converter circuit first and then with the positive output super lift Luo (POSLL) converter circuit again. A comparison was made between the two circuits, as well as a theoretical and simulation values were made and compared between them (in the same standard conditions) for each of these selected models. So as to improving solar system performance and clarify the functions played by POSLL in power electronic circuits.
The proportional integral derivative (PID) controllers are widely applied in industrial process owing to their simplicity and effectiveness for both linear and nonlinear systems, and the tuning methods still a hot research area to give the optimum result for control behavior. Fuzzy logic and proportional integral derivative (PID) controllers are designed and compared for use in control on-line an advanced biodiesel microwave reactor system which converts waste cooking oil into biodiesel by transesterification chemical process. A closed loop fuzzy and PID controllers are used to automatically and continuously adjust the applied power of microwave reactor under different perturbations. Labview based software tool will be presented and used for measurement and control of the full system, that will make charts real time display as well as state real time monitoring.
1 November 2026 in Journal of Engineering and Sustainable Development
This study investigates the effects of plasma surface treatment on the thermal and morphological properties of polyamide 12 (PA12) powder. The powders were treated for 1 h and 2 h under full power in an air environment. Thermogravimetric analysis (TGA) results demonstrated that the plasma action improved the maximum decomposition temperature from 449.3 °C for the untreated polyamide 12 to 461.7 °C for the 2-h-treated sample, indicating improved thermal stability. The analysis of differential scanning calorimetry (DSC) revealed a marked increase in the temperature of crystallization (Tc) from 133.31 °C for the untreated PA12 sample to 141.7 °C for the 2-h sample, while the melting temperature is approximately constant at 185 °C. The SEM images demonstrated that plasma treatment resulted in a roughened, more homogeneous surface morphology with significantly fewer surface defects and irregularities. Plasma treatment enhanced the wettability and water dispersion of PA12, as plasma-treated powders showed fast spreading and stable suspension in water due to the introduction of polar groups and increased surface pores. The change from a water-hating grouping to a water-loving scattering provides a strong basis for water-based processing and future composite design that will need strong interfacial interactions. Thus, these results confirmed the importance of plasma treatment as an environmentally friendly method in tailoring the properties of PA12 for UV-resistant applications.