30 June 2016 in Tribologia
The problems with lubrication in refrigeration compressors are usually caused by the presence of the oil-refrigerant mixture in friction nodes. One cannot assess lubricity properties of oil under its operating conditions based on test results that characterize oil exclusively. For this purpose, it is necessary to test the lubricity properties of the oil-refrigerant mixture. The article presents the concept of an assessment method for the lubricity properties of oils for refrigeration compressors in a mixture with a refrigerant. The essential elements of the proposed method are the procedure for selecting wear test duration time (τt) and the oil-refrigerant mixture formation time (τm).
30 June 2016 in Tribologia
Current legal regulations concerning ozone-depleting substances and greenhouse gases result in a dynamic return to the use of natural refrigerants such as hydrocarbons. However, they are gases included in the A3 (combustible) security group, and that is why they are now mainly used in devices with low performance (mainly in household refrigerators). The most widely used hydrocarbon as a refrigerant in this group of devices is R600a (isobutene). The article presents a comparative assessment of the lubricity properties of oil-refrigerant mixtures of three mineral oils with R600a. The assessment was based on a sample wear volume of the block-on-ring node under the conditions approximating the operation of the compressor after an extensive standstill period. The oil/refrigerant mixture was obtained as a result of an appropriately extended mutual contact of both substances in a closed chamber.
30 April 2018 in Tribologia
There has currently been a dynamic return to applying natural refrigerants such as hydrocarbons. They are substances containing neither fluorine nor chlorine, which contribute to the enlargement of the ozone hole and the greenhouse effect. However, hydrocarbons are the substances from the A3 safety group (flammable) and, at present, are mainly used in appliances of low efficiency. The most widely used refrigerant in this category of appliances is R600a (isobutene). While repairing refrigeration appliances, there is often the need to remove the refrigerant and compressor oil from the system. Any impurities in the system are also removed. Should incorrect removal of the used oil from the installation occur, there is the risk that a certain amount of the oil and flushing fluid shall remain in the refrigeration system. The article presents an evaluation of the effect of a flushing fluid for refrigeration systems on lubricity properties of compressor oils. The article also describes the research on the use of R600a, a mineral oil of VG ISO 32 and commercially available FF1 flushing fluid, for refrigeration systems. The evaluation was made on the basis of the sample wear volume in the block-on-ring node under the conditions similar to compressor exploitation following a longer shut-off period. Three different lubricants were compared: a mixture of mineral oil with FF1 flushing fluid for refrigeration systems in the amount 20% by volume, a mixture of mineral oil with FF1 flushing fluid for refrigeration systems in the amount 50% by volume, and a mixture of mineral oil with FF1 flushing fluid for refrigeration systems in the amount 50% by volume with R600a.