Hamidreza Aghasi

Hamidreza Aghasi

Auto-generated profile, based on publicly available information

Hamidreza Aghasi

Department of Electrical Engineering and Computer Science, High-Speed Integrated Electronics Laboratory, University of California at Irvine, Irvine, CA, USA

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 September 2015 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
RHRuonan Han
Ruonan Han
CJChen Jiang
Chen Jiang
AMAli Mostajeran
Ali Mostajeran
MEMohammad Emadi
Mohammad Emadi
HAHamidreza Aghasi
Hamidreza Aghasi
EAEhsan Afshari
Ehsan Afshari
A high-power 320 GHz transmitter using 130 nm SiGe BiCMOS technology (f T /f max = 220/280 GHz) is reported. This transmitter consists of a 4 × 4 array of radiators based on coupled harmonic oscillators. By incorporating a signal filter structure called return-path gap coupler into a differential self-feeding oscillator, the proposed 320 GHz radiator simultaneously maximizes the fundamental oscillation power, harmonic generation, as well as on-chip radiation. To facilitate the TX-RX synchronization of a future terahertz (THz) heterodyne imaging chipset, a fully-integrated phase-locked loop (PLL) is also implemented in the transmitter. Such on-chip phase-locking capability is the first demonstration for all THz radiators in silicon. In the far-field measurement, the total radiated power and EIRP of the chip is 3.3 mW and 22.5 dBm, respectively. The transmitter consumes 610 mW DC power, which leads to a DC-to-THz radiation efficiency of 0.54%. To the authors' best knowledge, this work presents the highest radiated power and DC-to-THz radiation efficiency in silicon-based THz radiating sources.

16 January 2017 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
HAHamidreza Aghasi
Hamidreza Aghasi
ACAndreia Cathelin
Andreia Cathelin
EAEhsan Afshari
Ehsan Afshari
We propose a nonlinear device model and a systematic methodology to generate maximum power at any desired harmonic. The proposed power optimization technique is based on the Volterra-Wiener theory of nonlinear systems. By manipulating the device nonlinearity and optimizing the embedding network, optimum conditions for harmonic power generation are provided. Using this theory, a 920-944-GHz frequency quadrupler is designed in a 130-nm SiGe:C process. The circuit achieves the peak output power of -17.3 and -10 dBm of effective isotropic radiated power and consumes 5.7 mW of dc power. To the best of our knowledge, this circuit demonstrates the highest generated power among Si/SiGe-based sources at this frequency range.

20 April 2020 in Applied Physics Reviews
Verified
Journal Article
Open access
PDF file
HAH. Aghasi
H. Aghasi
SNS. M. H. Naghavi
S. M. H. Naghavi
MTM. Tavakoli Taba
M. Tavakoli Taba
MAMohammed Aseeri
Mohammed Aseeri
ACA. Cathelin
A. Cathelin
EAE. Afshari
E. Afshari
We review the recent advances on the implementation of electronic circuits that operate in the millimeter-wave (30–300 GHz) and terahertz (300–3000 GHz) frequency ranges. The focus of this article is on nonlinear phenomena in electronics. The different implementations of nonlinear circuits for the sake of millimeter-wave and terahertz signal generation are studied in this paper. The challenges of signal generation are examined and the benefits and limitations of different schemes of signal generation are discussed. It is shown that nonlinear devices such as electronic transistors exhibit major advantages enabling realization of low-cost and portable circuits for the emerging applications in these frequency ranges. We also review linear and nonlinear design methodologies employing the properties of electromagnetic waves. The electronic systems designed based on the presented ideas are shown to push the previously unbeatable limits of operation in millimeter-wave and terahertz frequency ranges. A discussion on remaining challenges and future directions concludes the paper.

1 February 2015
Verified
Conference Paper
Closed access
RHRuonan Han
Ruonan Han
CJChen Jiang
Chen Jiang
AMAli Mostajeran
Ali Mostajeran
MEMohammad Emadi
Mohammad Emadi
HAHamidreza Aghasi
Hamidreza Aghasi
EAEhsan Afshari
Ehsan Afshari
Non-ionizing terahertz imaging using solid-state integrated electronics has been gaining increasing attention over the past few years. However, there are currently several factors that deter the implementations of fully-integrated imaging systems. Due to the lack of low-noise amplification above fmax, the sensitivity of THz pixels on silicon cannot match that of its mm-Wave or light-wave counterparts. This, combined with the focal-plane array configuration adopted by previous sensors, requires exceedingly large power for the illumination sources. Previous works on silicon have demonstrated 1mW radiation [1,3]; but higher power, as well as energy efficiency, are needed for a practical imaging system. In addition, heterodyne imaging scheme was demonstrated to be very effective in enhancing detection sensitivity [4]. Due to the preservation of phase information, it also enables digital beam forming with a small number of receiver units. This however requires phase locking between the THz source and receiver LO with a small frequency offset (IF<;1GHz). In [5], a 300GHz PLL is reported with probed output. In this paper, a 320GHz transmitter using SiGe HBTs is presented (Fig. 25.5.1). Combining 16 coherent radiators, this work achieves 3.3mW radiated power with 0.54% DC-RF efficiency, which are the highest among state-of-the-art silicon THz radiators shown in the comparison table in Fig. 25.5.6. Meanwhile, the output beam is phase-locked by a fully-integrated PLL, which enables high-performance heterodyne imaging systems.

7 January 2015 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
SSSoheil Saadat
Soheil Saadat
HAHamidreza Aghasi
Hamidreza Aghasi
EAEhsan Afshari
Ehsan Afshari
HMHossein Mosallaei
Hossein Mosallaei
A negative impedance converter (NIC) design is proposed to obtain a negative inductance of L=-1 nH operating from 0.1 to 6 GHz. The design is based on Linvill's open circuit stable topology, and it is implemented by 65 nm CMOS process to achieve a low power negative inductance integrated circuit. The NIC circuit is attached to a 1.2 V dc power supply and consumes 5 mW of power. The simulation and theoretical results are compared with the measurement, and good agreements are obtained.

28 February 2023 in IEEE Access
Verified
Journal Article
Open access
HMHedayatullah Maktoomi
Hedayatullah Maktoomi
SSSoheil Saadat
Soheil Saadat
OMOmeed Momeni
Omeed Momeni
PHPayam Heydari
Payam Heydari
HAHamidreza Aghasi
Hamidreza Aghasi
This paper provides an overview of broadband terahertz antenna elements and arrays for integrated communication systems. The fundamental challenges of integrated on-chip and off-chip antenna design, the trade-offs between performance metrics, and the impact of interface between the chip and off-chip antennas are studied in detail. The limitations and benefits of various interface technologies are discussed. The deployment of printed circuit boards (PCB) and flexible printed circuits (FPC) technologies for implementation of efficient broadband antennas is compared against on-chip counterparts. As a proof of concept, an off-chip antenna for the 91–134 GHz is presented.