Unlike other noise sources, which can be reduced or eliminated by different signal processing techniques, shot noise is an ever-present noise component in any imaging system. In this paper, we present an in-depth study of the impact of shot noise on time-of-flight sensors in terms of the error introduced in the distance estimation. The paper addresses the effect of parameters, such as the size of the photosensor, the background and signal power or the integration time, and the resulting design trade-offs. The study is demonstrated with different numerical examples, which show that, in general, the phase shift determination technique with two background measurements approach is the most suitable for pixel arrays of large resolution.
2 August 2013 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
In this article, we show that the dielectric constant of lead-free ferroelectric ceramics based on the solid solution (1-x)(Bi0.5Na0.5)TiO3-xBaTiO3, with compositions at or near the morphotropic phase boundary (MPB), can be tuned by a local applied electric field. Two compositions have been studied, one at the MPB, with x = 0.06 (BNBT6), and another one nearer the BNT side of the phase diagram, with x = 0.04 (BNBT4). The tunability of the dielectric constant is measured at microwave frequencies between 100 MHz and 3 GHz by a nonresonant method and simultaneously applying a dc electric field. As expected, the tunability is higher for the composition at the MPB (BNBT6), reaching a maximum value of 60% for an electric field of 900 V/cm, compared with the composition below this boundary (BNBT4), which saturates at 40% for an electric field of 640 V/cm. The high tunability in both cases is attributed to the fine grain and high density of the samples, which have a submicrometer homogeneous grain structure with grain size of the order of a few hundred nanometers. Such properties make these ceramics attractive for microwave tunable devices. Finally, we have tested these ceramics for their application as infrared pyroelectric detectors and we have found that the pyroelectric figure of merit is comparable to traditional lead-containing pyroelectrics.
7 November 2005 in IEEE Transactions on Microwave Theory and Techniques
Accurate and efficient empirical model generation techniques of microwave devices, for a large range of geometric and material parameters opportunely chosen, are presented. The empirical models are based on multiple linear regression approach, which compensates the error between an initial inaccurate empirical model and an electromagnetic (EM) full-wave solver (or measurement data). The aim of these techniques is to generate accurate empirical models, which are computationally very efficient with respect to any EM technique. These simple models could be integrated in a toolbox of any commercially available computed-aided design tools for RF/microwave circuits. Comparisons with artificial neural networks and linear-regression-based models are listed and discussed for the dispersion of a microstrip transmission line propagating the quasi-TEM mode and a microwave tunable phase shifter propagating the even mode.
1 November 2011 in Journal of Systems and Software
In this paper, a CMOS fourth-order low-frequency bandpass filter for passive pyroelectric infrared sensors is presented. The sensor is intended for use in wireless sensor nodes, demanding strict low power requirements. The final use of these sensor nodes is an ambient assisted living system for elderly people living alone at home. A NICERA RE200B passive pyroelectric infrared sensor with a measured steady operation current of 3.5 μA has been used. The filter has been implemented cascading two biquad OTA-C filtering stages. OTA-C topology has been selected due to the extremely large time constant of the filter. The second-order stage circuit has been prototyped in a 0.35-μm CMOS process and power consumption is below 6.5 μW from a 3 V supply. A central frequency of 1.49 Hz, with Q = 0.5, and a gain of 45 V/V was achieved.