Guntars Vaivars

Guntars Vaivars

Auto-generated profile, based on publicly available information

Guntars Vaivars

University of Latvia

Research Focus & Metrics

Academic Career Length

34Years (1993-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 May 2022 in Polymer Degradation and Stability
Verified
Journal Article
Open access
EPElina Pajuste
Elina Pajuste
IRI. Reinholds
I. Reinholds
GVG. Vaivars
G. Vaivars
AAA. Antuzevičs
A. Antuzevičs
LALiga Avotina
Liga Avotina
RKR. Kaparkalējs
R. Kaparkalējs

29 June 2022 in Nanomaterials
Verified
Journal Article
Open access
PDF file
ABAndris Berzins
Andris Berzins
HGHugo Grube
Hugo Grube
ESEinars Sprugis
Einars Sprugis
GVGuntars Vaivars
Guntars Vaivars
IFIlja Fescenko
Ilja Fescenko
The implantation of diamonds with helium ions has become a common method to create hundreds-nanometers-thick near-surface layers of NV centers for high-sensitivity sensing and imaging applications; however, optimal implantation dose and annealing temperature are still a matter of discussion. In this study, we irradiated HPHT diamonds with an initial nitrogen concentration of 100 ppm using different implantation doses of helium ions to create 200-nm thick NV layers. We compare a previously considered optimal implantation dose of ∼1012 He+/cm2 to double and triple doses by measuring fluorescence intensity, contrast, and linewidth of magnetic resonances, as well as longitudinal and transversal relaxation times T1 and T2. From these direct measurements, we also estimate concentrations of P1 and NV centers. In addition, we compare the three diamond samples that underwent three consequent annealing steps to quantify the impact of processing at 1100 °C, which follows initial annealing at 800 °C. By tripling the implantation dose, we have increased the magnetic sensitivity of our sensors by 28±5%. By projecting our results to higher implantation doses, we demonstrate that it is possible to achieve a further improvement of up to 70%. At the same time, additional annealing steps at 1100 °C improve the sensitivity only by 6.6 ± 2.7%.

6 September 2023 in Materials
Verified
Journal Article
Open access
PDF file
LPLaura Dace Pakalniete
Laura Dace Pakalniete
EMElizabete Maskova
Elizabete Maskova
RZRudolfs Janis Zabolockis
Rudolfs Janis Zabolockis
LALiga Avotina
Liga Avotina
ESEinars Sprugis
Einars Sprugis
EPElina Pajuste
Elina Pajuste
Sulfonated poly(ether ether ketone) (SPEEK) materials are promising candidates for replacing Nafion™ in applications such as proton exchange membrane (PEM) and direct methanol fuel cells. SPEEK membranes have several advantages such as low cost, thermal and radiation stability and controllable physicochemical and mechanical properties, which depend on the degree of sulfonation (DS). Commercial PEEK was homogenously sulfonated up to a DS of 60–90% and the membranes were prepared using a solvent casting method. Part of the samples were irradiated with a 10 MeV electron beam up to a 500 kGy dose to assess the ionizing radiation-induced effects. Both non-irradiated and irradiated membranes were characterized by Fourier Transformation infrared (FT-IR) spectroscopy, thermogravimetric analysis (TGA), proton nuclear magnetic resonance (1H-NMR) spectroscopy, electrochemical impedance analysis and, for the first time for non-irradiated membranes, by spectrophotometric analysis with Cr(III). The above-mentioned methods for application for DS assessment were compared. The aim of this study is to compare different methods used for the determination of the DS of SPEEK membranes before and after high-dose irradiation. It was observed that irradiated membranes presented a higher value of DS. The appearance of different new signals in 1H-NMR and FT-IR spectra of irradiated membranes indicated that the effects of radiation induced changes in the structure of SPEEK materials. The good correlation of Cr(III) absorption and SPEEK DS up to 80% indicates that the spectrophotometric method is a comparable tool for the characterization of SPEEK membranes.

1 June 2020 in Key Engineering Materials
Verified
Journal Article
Open access
PDF file
GVGuntars Vaivars
Guntars Vaivars
KKKristine Krukle-Berzina
Kristine Krukle-Berzina
MMMadara Markus
Madara Markus
SPEEK (sulfonated polyether ether ketone) membranes have been prepared and characterized. The SPEEK membrane geometry and theoretical vibration spectra calculated using density functional theory (DFT) as depending from membrane chain length and polymer cross-linking. Analyzed the limitations of the method by comparing theoretical and experimental IR spectra.

1 May 1993 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
Janis Janis KleperisJanis Janis Kleperis
Janis Janis Kleperis
GVG. Vaivars
G. Vaivars
Gunars BajarsGunars Bajars
Gunars Bajars
AKA. Kranevskis
A. Kranevskis
ALA. Lūsis
A. Lūsis
GVG. Vītinš
G. Vītinš

10 February 2023 in Journal of Solid State Electrochemistry
Verified
Journal Article
Closed access
PDF file
Janis Janis KleperisJanis Janis Kleperis
Janis Janis Kleperis
Gunars BajarsGunars Bajars
Gunars Bajars
LGLiga Grinberga
Liga Grinberga
GVGuntars Vaivars
Guntars Vaivars
JPJuris Purans
Juris Purans
GKGints Kucinskis
Gints Kucinskis