This paper presents a previously unreported mechanism for the formation of High Spatial Frequency Laser Induced Periodic Surface Structures (HSFL) in GaAs upon irradiation by femtosecond laser pulses (repetition rate = 1 kHz, τ = 150 fs, λ = 390 nm) that is driven by point defect diffusion, desorption of surface atoms, and roughening of the surface. The HSFL have trenches that are 100 nm deep, an average spatial period of 65 nm, and are completely below the original surface. Sub-100 nm periodicity with high depth to period aspect ratio has not been previously observed in GaAs. In the proposed mechanism, laser irradiation generates point defects that diffuse to the surface. Interstitials that reach the surface can be easily desorbed and the remaining vacancies coalesce into vacancy islands. This results in a rough surface, which can excite surface plasmon polaritons. Despite our observations of periodicity corresponding to SPPs, calculations done using the excited dielectric function indicate that SPPs should not be supported. This points to the need to incorporate the cumulative effects of laser irradiation in existing models. This paper also presents evidence that desorption can also occur during HSFL formation in GaAs when irradiated with 780 nm in vacuum. The HSFL have the similar spatial period as GaAs irradiated in air with 780 nm, but completely below the original surface.
Lattice-core sandwich structure metamaterials are lightweight alternatives to monolithic materials that can present better mechanical, thermal, and energy dampening performance. Manufacturing lattice metamaterials to follow curved surfaces can pose a challenge, as the lattices rely on their geometric orientation to the substrate for their mechanical properties. This work rationally designed a lattice structure where the surface is broken up into “petals” connected to the underlying lattice, which localizes the petals’ impact response. This design opens a pathway for implementation of lattice-core sandwich structures onto complex surface geometries. These petal structures were evaluated for their energy absorption efficiency experimentally by utilizing pressure waves generated with nanosecond lasers and computationally via finite element modeling. The lattice structures exhibited a two-orders-of-magnitude decrease in transmitted pressure compared to their constituent steel at equivalent mass. Furthermore, localizing energy absorption into petal structures provided a 44% reduction in peak load compared to a continuous “single-petal” design.
Phase transformations under high strain rates (dynamic compression) are examined in situ on ZrW2O8, a negative thermal expansion ternary ceramic displaying polymorphism. Amorphization, consistent with prior quasi-static measurements, was observed at a peak pressure of 3.0 GPa under dynamic conditions, which approximate those expected during fabrication. Evidence of partial amorphization was observed at lower pressure (1.8 GPa) that may be kinetically restrained by the short (<∼150 ns) time scale of the applied high pressure. The impact of kinetics of pressure-induced amorphization from material fabrication methods is briefly discussed.
This work presents an ultrafast laser-based mechanism for achieving liquid-like mass transport rates in solids. Transport at these rates was achieved by irradiating GaAs with a femtosecond laser (repetition rate = 1 kHz, τ = 150 fs, and λ = 780 nm). Following irradiation, the material exists in a highly excited state in which the atomic bonds are softened. The probability of hopping between lattice/interstitial sites for atoms within the softened interatomic potentials is greatly increased. Evidence of the enhanced diffusion is observable in the rate at which islands and corrugated structures form on the GaAs surface. Quantification of the mass transport rate necessary to form the structures via Fick's law produces a diffusion coefficient of 1.18×10−6 cm2/s, which is over 10 orders of magnitude higher than that for near-melt vacancy self-diffusion in crystalline GaAs. In fact, the calculated diffusion coefficient is on the order of magnitude of liquid GaAs, while estimates of temperature during mass transport place the crystal well below its melting point. These results suggest that ultrafast laser irradiation can be used to enhance the diffusion rate in materials without inducing a phase transition.