Microstructure plays an essential role in the control of hydrogel properties. It is also an important factor when cells or drugs are encapsulated inside the hydrogel. In this work, the microstructures of hydrazone crosslinked hyaluronan-, alginate- and gellan gum-based hydrogels were evaluated thoroughly for the first time by using rheology- and diffusion (fluorescence recovery after photobleaching, FRAP)-based methods. The effect of gel parameters on the viscoelastic and diffusion properties of hydrogels, and further on their structural parameters (mesh size, average molecular weight of the polymer chain between neighboring crosslinks, crosslinking density) are shown. Results further show that diffusivity decreased when larger dextran sizes were used, which were equivalent to the mesh sizes of hydrogels (15 nm to 47 nm) evaluated by the rheological method. This mesh size range allows the transportation of smaller molecules, but also peptides and most of the proteins. A correlation between the storage modulus and the structural parameters was also shown. Overall, hydrazone crosslinking offers an easy way to produce polysaccharide-based hydrogels with variable microstructures by altering the gel parameters.
13 February 2020 in ACS Applied Materials & Interfaces
In recent years, additive manufacturing of polydimethylsiloxane (PDMS) has gained interest for the development of soft electronics. To fabricate complex electrical devices, fabrication of multilayered structures is required. We propose here a straightforward digital printing fabrication process of silicone rubber-based, multilayered electronics. An inkjet-printable PDMS solution was developed for digital patterning of elastomeric structures. The silicone ink was used together with a highly conductive silver nanoparticle (Ag np) ink for the fabrication of the all-inkjet printed and multilayered electrical devices. The application of the multilayer circuit board was successful. The sheet resistances were below 0.3 Ω/□, with a conductive layer thickness less than 1 µm. The electrical insulation between the conductive layers was done by printing 20-25 µm thick dielectric PDMS layer selectively on top of the bottommost conductive layer.
Neural tissue engineering and three-dimensional in vitro tissue modeling require the development of biomaterials that take into account the specified requirements of human neural cells and tissue. In this study, an alternative method of producing biomimetic hydrogels based on gellan gum (GG) was developed by replacing traditional crosslinking methods with the bioamines spermidine and spermine. These bioamines were proven to function as crosslinkers for GG hydrogel at +37 °C, allowing for the encapsulation of human neurons. We studied the mechanical and rheological properties of the formed hydrogels, which showed biomimicking properties comparable to naïve rabbit brain tissue under physiologically relevant stress and strain. Human pluripotent stem cell-derived neuronal cells demonstrated good cytocompatibility in the GG-based hydrogels. Moreover, functionalization of GG hydrogels with laminin resulted in cell type-specific behavior: neuronal cell maturation and neurite migration.
1 April 2018 in Materials Science and Engineering: C