Rezeda E. Mukhamatdinova

Rezeda E. Mukhamatdinova

Auto-generated profile, based on publicly available information

Rezeda E. Mukhamatdinova

Институт геологии и нефтегазовых технологий ФГАОУ ВО Казанского (Приволжского) федерального университета (ИГиНГТ К(П)ФУ)

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 May 2023 in Catalysts
Verified
Journal Article
Open access
PDF file
YAYasser Ibrahim Ibrahim Abdelsalam
Yasser Ibrahim Ibrahim Abdelsalam
Firdavs AlievFirdavs Aliev
Firdavs Aliev
Oybek MirzaevOybek Mirzaev
Oybek Mirzaev
Sergey SitnovSergey Sitnov
Sergey Sitnov
VKVLADIMIR KATNOV
VLADIMIR KATNOV
Alexey VakhinAlexey Vakhin
Alexey Vakhin
Aquathermolysis is one of the crucial processes being considered to successfully upgrade and irreversibly reduce the high viscosity of heavy crude oil during steam enhanced oil recovery technologies. The aquathermolysis of heavy oil can be promoted by transition metal-based catalysts. In this study, the catalytic performance of two water-soluble catalysts Ni(CH3COO)2 and Zn(CH3COO)2 on the aquathermolytic upgrading of heavy oil at 300 °C for 24 h was investigated in a high pressure–high temperature (HP-HT) batch reactor. The comparison study showed that nickel acetate is more effective than zinc acetate in terms of viscosity reduction at 20 °C (58% versus 48%). The viscosity alteration can be mainly explained by the changes in the group composition, where the content of resins and asphaltenes in the upgraded heavy crude oil sample in the presence of nickel catalyst was reduced by 44% and 13%, respectively. Moreover, the nickel acetate-assisted aquathermolysis of heavy oil contributed to the increase in the yield of gasoline and diesel oil fractions by 33% and 29%, respectively. The activity of the compared metal acetates in hydrogenation of the crude oil was judged by the results of the atomic H/C ratio. The atomic H/C ratio of crude oil upgraded in the presence of Ni(CH3COO)2 was significantly increased from 1.52 to 2.02. In addition, the catalyst contributed to the desulfurization of crude oil, reducing the content of sulfur in crude oil from 5.55 wt% to 4.51 wt% The destructive hydrogenation of resins and asphaltenes was supported by the results of gas chromatography-mass spectroscopy (GC-MS) and Fourier-transform infrared (FT-IR) spectroscopy analysis methods. The obtained experimental results showed that using water-soluble catalysts is effective in promoting the aquathermolytic reactions of heavy oil and has a great potential for industrial-scale applications.

18 October 2022 in Catalysts
Verified
Journal Article
Open access
PDF file
Irek MukhamatdinovIrek Mukhamatdinov
Irek Mukhamatdinov
ALArtem V. Lapin
Artem V. Lapin
RMRezeda E. Mukhamatdinova
Rezeda E. Mukhamatdinova
AAAydar Akhmadiyarov
Aydar Akhmadiyarov
BABoudkhil Affane
Boudkhil Affane
Alexey VakhinAlexey Vakhin
Alexey Vakhin
In this work, a synthesis of an oil-soluble iron-based catalyst precursor was carried out and its efficiency was tested in a laboratory simulation of the aquathermolysis process at different temperatures. The rocks of the Usinskoe field from the Permian deposits of the Komi Republic, obtained by steam-gravity drainage, and the iron-based catalyst precursor, as well as the products of non-catalytic and catalytic aquathermolysis, were selected as the object of study. As a result, it was found that the content of alkanes in the samples after thermal steam treatment (TST) at 300 °C increased 8-fold compared to the original oil, and the content of cycloalkanes in the sample with the catalyst increased 2-fold compared to the control experience. This may indicate that not only the carbon-heteroatom bonds (C-S, N, O) but also the C-C bonds were broken. It also shows that increasing the iron tallate concentration at TST 300 °C leads to a decrease in the molecular mass of the oil compared to the control experiment. According to SEM, the catalyst is nanodisperse particles with a size of ≈60–80 nm, which are adsorbed on the rock surface, catalyst removal occurs at a small scale.

20 January 2025 in Chemengineering
Verified
Journal Article
Open access
PDF file
MAMohammed O.N. Ali
Mohammed O.N. Ali
Irek MukhamatdinovIrek Mukhamatdinov
Irek Mukhamatdinov
BABoudkhil Affane
Boudkhil Affane
RMRezeda E. Mukhamatdinova
Rezeda E. Mukhamatdinova
VKVLADIMIR KATNOV
VLADIMIR KATNOV
Alexey VakhinAlexey Vakhin
Alexey Vakhin
In this study, an examination was conducted of the influence of iron tallate on the composition and properties of highly viscous oil from the Strelovskoye deposit in the Samara region under thermal–catalytic treatment (TCT). The research revealed that the dynamic viscosity of the oil following TCT at 300 °C, with a measurement temperature of 20 °C, decreased by a factor of 8 in comparison to the initial sample and nearly 4.5 times compared to the control sample at the 96-h mark. The most promising results in reducing the pour point temperature to 7 °C were identified following a 96-h TCT at 300 °C. This reduction was attributed to the decrease in paraffin content facilitated by the presence of the catalyst. According to the ICP-MS results, the extraction of the catalyst with the oil amounted to only 1%. This indicates that during the implementation of TCT within the reservoir, the catalyst is likely to adsorb onto the rock surfaces.

30 March 2026 in Нефтяная провинция
Verified
Journal Article
Open access
Irek MukhamatdinovIrek Mukhamatdinov
Irek Mukhamatdinov
РМР.э. Мухаматдинова
Р.э. Мухаматдинова
АВА.в. Вахин
А.в. Вахин
В данной работе проведено изучение состава и структуры преобразования высоковязкой нефти в гидротермальных условиях, сформированных in situ из нефтерастворимого прекурсора на основе железа и кобальта. Установлено, что под действием катализаторов на основе переходных металлов происходит деструкция смол и асфальтенов. Опыты проведены с использованием нефтерастворимых таллатов железа и кобальта в присутствии донора водорода. Найдено, что применение прекурсоров катализатора влияет на газовый состав продуктов акватермолиза, реологические свойства и компонентный состав. При термокаталитическом воздействии с добавлением таллата кобальта было отмечено снижение вязкости в 2,5 раза при 150°С и в 1,5 раза при 200°С. Подобное снижение в 1,5 раза наблюдается и при использовании прекурсора катализатора на основе железа. This paper examines the composition and structure of high-viscosity oil formed in situ from an oil-soluble iron- and cobalt-based precursor under hydrothermal conditions. It was found that resins and asphaltenes are destroyed by transition metal catalysts. Experiments were conducted using oil-soluble iron and cobalt carboxylates in the presence of a hydrogen donor. The use of catalyst precursors was found to affect the gas composition of the aquathermolysis products, their rheological properties, and their component composition. Thermal catalytic action with the addition of cobalt tallate resulted in a 2.5-fold decrease in viscosity at 150°C and a 1.5-fold decrease at 200°C. A similar 1.5-fold decrease was also observed with an iron-based catalyst precursor.