This article presents an energy-efficient high-resolution dual-residue (D-R) pipelined-successive approximation register (SAR) analog-to-digital converter (ADC), with a backend capacitive interpolating SAR ADC incorporated with noise-shaping (NS) capability. The residue amplifier design could be simplified as the residue is pre-amplified by the amplifier for the kT/ $C$ -noise cancellation. Moreover, the proposed segmented digital-to-analog converter (DAC) structure overcomes parasitic capacitance limitations in the capacitive interpolation, improving resolution along with the gain-error-free advantage of the D-R structure. Fabricated in a 180-nm CMOS technology, the prototype ADC achieves an 81.2-dB signal-to-noise and distortion ratio (SNDR) and an 89.9-dB spurious-free dynamic range (SFDR) in a 1.5-MHz bandwidth (BW) at an over-sampling ratio (OSR) of 8 with a 170.4-dB SNDR Schreier figure-of-merit (FoM) without any calibration.
15 October 2025 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents a 12-bit pipelined analog-to-digital converter (ADC) featuring a two-stage high-gain dynamic amplifier (DA) architecture. The first stage employs a gain-boosting floating inverter amplifier (GB-FIA) to achieve high DC gain and power efficiency. By using a current-controlled delay cell, the partial FIA (P-FIA) based second stage with input dynamic bias could ensure stability, faster slewing behavior and power efficiency for the residue amplifier (RA). Additionally, a modified bootstrapped switch (BTS) with improved start-up speed reduces sample-dependent nonlinearity in the multiplying digital-to-analog converter (MDAC) during the non-overlapping phase. Fabricated in a 28-nm CMOS process, the prototype ADC achieves a signal-to-noise-and-distortion ratio (SNDR) of 58.9 dB at a Nyquist-rate input with a 600 MS/s sampling rate. Operating at a 0.9-V supply, it consumes 15.6 mW, achieving a Schreier figure-of-merit (FoM) of 161.8 dB. Notably, without gain calibration, the ADC maintains a spurious-free dynamic range (SFDR) exceeding 77 dB across the Nyquist bandwidth, attributed to its sufficient loop gain, wide output swing, and dedicated reset phase.
10 March 2026 in IEEE Journal of Solid-State Circuits
This article presents a spur-suppressed background calibration technique for high-speed current-steering digital-to-analog converters (DACs), based on a paired current source (CS) switching scheme. In conventional background calibration, periodic switching of CSs to and from the calibration mode introduces unwanted glitches that appear as spurious tones. The proposed technique introduces an intermediate common-state mode, where paired CSs steer equal and opposite currents to the differential output before entering or exiting calibration. This effectively cancels switching-induced glitches by common-mode (CM) rejection without compromising signal power or increasing noise. A 12-bit 1-GS/s DAC was fabricated in 28-nm FDSOI technology to validate the proposed method. Measurement results show that the proposed calibration achieves a spur-suppressed operation with an SFDR of 81-dBc near DC and greater than 70 dBc up to 286 MHz, with improved INL and DNL performance. The prototype DAC consumes 33 mW and achieves a figure of merit (FoMW,BW) of 28.4 fJ/conversion-step, demonstrating high linearity and power efficiency.