Integrating photovoltaics into buildings, parking shelters, street furniture, and crops can support the transition to sustainable electricity management. Yet, these devices must manage light to generate energy while ensuring visual comfort before being launched to market. Here, semi-transparent perovskite solar cells (PSCs) in n-i-p architecture have been engineered to meet the requirements for adequate transparency while maintaining high power conversion efficiency. The atomic layer deposited TiO2 compact layer outperformed the traditional spray pyrolysis one thanks to minimised parasitic absorptions and prevented shunt paths. Additionally, to ensure efficient transmittance in the visible light range, the halide perovskite composition is based on a mixture of Cs and formamidinium, yielding a high quality, amber coloured light absorber that reduces glare. Even though the devices studied here employed a semi-transparent gold rear electrode, they achieved an average visible transmittance (AVT) of 7.49%, a power conversion efficiency (PCE) of 13.41%, and a light utilisation efficiency (LUE) of 1.00%. The rear contact remains the primary optical constraint, but the front-end architecture developed wants to serve as a robust model to push further development. By combining this optimized front end with emerging transparent rear electrodes, the potential of semi-transparent PSCs can be unlocked.
Cu 2 MnSnS 4 (CMTS) is regarded as an emerging absorber for thin-film photovoltaic (PV) devices. In this work, CMTS thin films prepared using a low-cost, straightforward solution-based technique were extensively characterized, and the results were correlated with the preparation conditions and corresponding PV performances. X-ray diffraction techniques have been used to study crystallographic structure and microstructural parameters, while energetic band positions were depicted exploiting photoelectron yield spectroscopy and Kelvin probe measurements. The importance of fine-tuning the composition of the starting solution and the beneficial effect of post-deposition treatments were consequently highlighted. A strategy of slow cooling after annealing was studied, resulting in a new record for wet-prepared CMTS, with a champion device yielding 0.97% efficiency 5 months after the first PV measurement. Factors responsible for the typical modest efficiencies of CMTS have been investigated: photoluminescence revealed the presence of intra-gap defects, magnetic characterization revealed room-temperature short-range magnetic ordering, and electrical transport and thermal measurements highlighted a semimetallic-like character, all of which are barriers to achieving high PV performance in CMTS-based devices. Moreover, magnetometry indicates a weakly ordered spin-glass-like state, providing insight into the electronic correlations underlying the observed transport behavior.