27 October 2022 in Neurological Sciences
1 November 2020 in Materials Research Express
AISI 304 stainless steel was nitrided at different temperature in the plasma equipment using a new auxiliary device. The proposed hollow cathode auxiliary device improves the plasma density, thereby accelerating the nitriding process. The modified surface was characterized by x-ray diffraction, scanning and transmission electron microscopies, atomic force microscopy, surface microhardness testing. Electrochemical corrosion test was used to measure the localized corrosion resistance of the samples. Single S-phase layer without the CrN precipitation was obtained by hollow cathode plasma nitriding at 450 °C, which improved the microhardness, wear and corrosion resistance of the steel surface. Nitriding at higher temperature of 550 °C resulted in substitution of the S-phase towards layer composed from CrN and α-Fe phases, improving the microhardness but decreasing the corrosion resistance.
30 August 2022 in Ceramics International
24 January 2023 in Physica Scripta
The formation and diffusion of plasma are complex and critical processes in plasma nitriding. A stable and high-concentration plasma atmosphere can effectively increase the diffusion rate and the thickness of the diffusion layer. In this study, a two-dimensional multi-physics model integrating physical kinetics, energy transfer, mass transfer, and electromagnetic induction was developed. The effect of a hollow-cathode structure on plasma distribution was investigated, and the edge effect observed on nitrided metals was eliminated. The impacts of the essential plasma diffusion parameters were simulated using the developed model. A simple but effective experiment was designed to validate the model. A diffusion furnace with DC and RF dual discharge was designed by adding a high-frequency coil to existing equipment. Subsequently, the effects of the two plasma excitation sources on the overall distribution of plasma were analyzed. Notably, the proposed model is a high-fidelity one based on actual device dimensions; therefore, it can be used to simulate, predict, and control the plasma formation process in the diffusion furnace. In addition, the model can provide reference data and guidance for optimizing the diffusion process and structural design of diffusion furnaces.
8 October 2017 in SAE International Journal of Advances and Current Practices in Mobility
The present work aims at optimizing diesel engine combustion efficiency with optimized water injection strategy. The engine had been modified based on a two-cylinder mechanical pump diesel engine into common rail diesel engine with capability of direct water injection. The direct water injection system was designed and manufactured independently. An air-fluid booster was utilized to establish the water injection pressure up to 40MPa. Customized diesel injector was selected to be used as water injector in this study. Water injection strategy was optimized in detail with injection timing around TDC which ranges from 12°CA BTDC to -5°CA BTDC under 10 bar IMEP. The engine efficiency can be improved under selected water injection strategy due to the increment of work fluid in the combustion chamber. Moreover, the nitric oxides emissions show decrement around 10%. As the water injection timing approaching TDC, the efficiency enhancement rate increased and reached its peak value at 5°CA BTDC. The enhancement rate dropped as the injection timing further postpones. The water injection timing shows little effect on the nitric oxides emissions under the selected water injection duration. It can be predicted that the enhancement rate can be improved as engine load increases.