We present a continuous analytic current-voltage (I-V) model for cylindrical undoped (lightly doped) surrounding gate (SGT) MOSFETs. It is based on the exact solution of the Poisson's equation, and the current continuity equation without the charge-sheet approximation, allowing the inversion charge distribution in the silicon film to be adequately described. It is valid for all the operation regions (linear, saturation, subthreshold) and traces the transition between them without fitting parameters, being ideal for the kernel of SGT MOSFETs compact models. We have demonstrated that the I-V characteristics obtained by this model agree with three-dimensional numerical simulations for all ranges of gate and drain voltages.
1 August 2005 in Sensors and Actuators B: Chemical
We present a compact model based on the Landauer transmission theory for the silicon quantum wire and quantum well metal-oxide-semiconductor field effect transistor (MOSFET) working in the ballistic limit. This model captures the static current-voltage characteristics in all the operation regimes, below and above threshold voltage. The model provides a basic framework to account for the electronic transport in MOSFETs, being easily adaptable to gate structures such as the double-gate or gate-all-around. Numerical simulations based on the proposed model have been compared with experiments and quantum mechanical self-consistent simulations, with good agreement.
We report on an exhaustive and systematic study about the photoluminescent properties of nanoporous anodic alumina membranes fabricated by the one-step anodization process under hard conditions in oxalic and malonic acids. This optical property is analysed as a function of several parameters (i.e. hard anodization voltage, pore diameter, membrane thickness, annealing temperature and acid electrolyte). This analysis makes it possible to tune the photoluminescent behaviour at will simply by modifying the structural characteristics of these membranes. This structural tuning ability is of special interest in such fields as optoelectronics, in which an accurate design of the basic nanostructures (e.g. microcavities, resonators, filters, supports, etc.) yields the control over their optical properties and, thus, upon the performance of the nanodevices derived from them (biosensors, interferometers, selective filters, etc.)
A detailed study of the pore-widening rate of nanoporous anodic alumina layers as a function of the anodization voltage was carried out. The study focuses on samples produced under the same electrolyte and concentration but different anodization voltages within the self-ordering regime. By means of ellipsometry-based optical characterization, it is shown that in the pore-widening process, the porosity increases at a faster rate for lower anodization voltages. This opens the possibility of obtaining three-dimensional nanostructured nanoporous anodic alumina with controlled thickness and refractive index of each layer, and with a refractive index difference of up to 0.24 between layers, for samples produced with oxalic acid electrolytes.
Modifying the diameter of the pores in nanoporous anodic alumina opens new possibilities in the application of this material. In this work, we review the different nanoengineering methods by classifying them into two kinds: in situ and ex situ. Ex situ methods imply the interruption of the anodization process and the addition of intermediate steps, while in situ methods aim at realizing the in-depth pore modulation by continuous changes in the anodization conditions. Ex situ methods permit a greater versatility in the pore geometry, while in situ methods are simpler and adequate for repeated cycles. As an example of ex situ methods, we analyze the effect of changing drastically one of the anodization parameters (anodization voltage, electrolyte composition or concentration). We also introduce in situ methods to obtain distributed Bragg reflectors or rugate filters in nanoporous anodic alumina with cyclic anodization voltage or current. This nanopore engineering permits us to propose new applications in the field of biosensing: using the unique reflectance or photoluminescence properties of the material to obtain photonic barcodes, applying a gold-coated double-layer nanoporous alumina to design a self-referencing protein sensor or giving a proof-of-concept of the refractive index sensing capabilities of nanoporous rugate filters.