1 August 2022 in Journal of Materials in Civil Engineering
This paper outlines a framework for a potential testing protocol in which specimens are cast following typical industry practices, cured following a specific combination of insulting blocks and variable temperature boundary conditions, and then tested to approximate in-place mechanical properties. Protocols to cure specimens following a time–temperature profile of a high-strength concrete mass placement were developed so that mechanical properties can be measured directly. Findings showed that laboratory equipment was capable of replicating time–temperature profiles of mass concrete structures, and one protocol was recommended for a specific set of conditions. This framework is envisioned to be the foundational component of a standard method in which in-place properties of mass high-strength concrete placements can be predicted by a commercial testing laboratory that already conducts standard concrete tests. Future work is needed to extrapolate the proposed framework for different mixtures, placement sizes, and insulation types; this paper validates that the framework is possible.
1 March 2019 in Advances in Civil Engineering Materials
This research focused on improving ultra high-performance concrete (UHPC) toughness through the addition of annealed plain carbon steel fibers and stainless steel fibers that both exhibit increased ductility and strain hardening compared with conventional steel fibers used for concrete reinforcement. Implementing optimized heat treatments and selecting proper alternative alloys can improve the postyield carrying capacity of UHPCs through plastic deformations, phase transformations, and fiber pullout. This research focused on the flexural response and dynamic penetration resistance of a UHPC known as Cor-Tuf with three different steel fiber types: plain carbon steel, stainless steel that can exhibit phase transformation-induced plasticity, and annealed carbon steel with reduced tensile strength but increased ductility and strain hardening. Annealed carbon steel fibers were able to reduce mass loss by 0.8 % for 5-cm-thick dynamic impact panels. By using a phase-transformable stainless steel, the ultimate flexural strength increased from 32.0 to 42.5 MPa (33 % increase) and the postimpact velocity decreased an average of 31.5 m/s for 2.5 and 5-cm-thick dynamic impact panels. Phase transformations (austenitic to martensitic) were quantified in the stainless steel fibers of postyielded UHPC specimens using a vibrating sample magnetometer. Stainless steel fibers sampled from the postyielded tensile face of a flexural beam increased from 75 to 107 emu/g. The results of the study evidence improvements in tensile properties and toughness that can be accomplished by modifying the stress versus strain response of steel fiber reinforcement and including new energy dissipation mechanisms such as phase transformation.